Turn any surface into a printable sheet for inkjet printers!
Digital Ground White (Matte) 15ml – A semi-opaque white ground suitable for printing onto a large variety of porous and non-porous surfaces. The smooth and absorbent surface allows printing inks to dry rapidly, making it an ideal starting product for artists exploring digital printing. The smooth and absorbent surface allows printing inks to dry rapidly, making it an ideal choice for all ink-jet printers, including desktop models that have ejection rollers or pizza wheels that come into contact with the printed surface.
Digital Ground Clear (Gloss) 15ml – A clear gloss ground for use on most porous surfaces where clarity is desired to view underlying materials. Like most clear ink-jet receptive coatings, prints done on this ground will dry more slowly, which can cause tracking problems for desktop printers that have ejection rollers or pizza wheels.
Digital Ground for Non Porous Surfaces 15ml – A clear gloss ground for coating non-porous surfaces, such as plastic and metal, when clarity is desired. Like most clear ink-jet receptive coatings, prints done on this ground will dry more slowly, which can cause tracking problems for desktop printers that have ejection rollers or pizza wheels.
RARE - Discontinued items
I have 10 kits available, with 3 bottles - one bottle of each digital ground (as pictured). I also have many bottles available for purchase as single units.
SKUs: #3566-S, #3563-S, #3564-S
USEFUL INFORMATION
Application Instructions
Product is ready to apply. If desired, can be thinned with up to10% water.
Using a foam brush, or foam roller, apply even coats of the Digital Grounds to the substrate. Other types of brushes or rollers may be used but test for your application as these might create a less even and more textured surface. Apply product quickly to allow the film sufficient time to level. Allow each layer to dry thoroughly before recoating. Two or more coats, applied in opposite directions, will typically provide the most uniform coating and best results.
Please note: Because the Digital Ground Clear (Gloss) and the Digital Ground for Non-Porous Surfaces are water-sensitive, additional coats can exhibit excessive brush drag during the application, especially if the initial coat has not dried sufficiently.
Allow 8-12 hours after applying the last coat before printing.
Temperature
Minimum film formation temperature is 49°F / 9°C.
Clean Up
Clean tools with soap and water.
FINAL PROTECTION
Like all printmaking and photographic processes, digital media remain vulnerable to water sensitivity, fading caused by UV exposure and airborne pollutants, surface abrasion, and dirt. Unless planning to frame and mount the piece behind glass, some form of final protection is strongly recommended. Without it, the print can be easily damaged and its longevity greatly shortened. There are several Golden products we would recommend for this purpose:
GOLDEN Gel Topcoats w/ UVLS: Whether used as part of a final layer in a piece, or applied solely for protection at the end, the Gel Topcoats w/UVLS will provide substantial UV protection while lowering the risk of water and chemical sensitivity as well as direct exposure to environmental elements. However, because they are water-based, care must be taken when applying them over any water-sensitive materials or substrates, including those coated with the Digital Ground Clear (Gloss) or Digital Ground for Non-Porous Surfaces. One should always test for their application and if any blurring or lifting of color occurs then take steps to initially seal the surface with either GOLDEN Archival Spray Varnish or MSA Varnish. Also, please note that pieces coated with the Gel Topcoat w/UVLS will remain susceptible to dirt collection over time, not to mention surface damage from handling or shipping. For best practice and to address longer-term concerns of cleaning and conservation, we would still recommend applying one of our removable varnishes as a final layer.