Dental Lab Electrolytic Polishing Machine Electro Polisher Unit With Two Electrolytic Cells
 
1.Main Features and Uses
This machine adopts constant current and constant voltage technology, with overload and overheat protection, to completely solve the failure of traditional electrolytic machines that frequently burn fuses or burn components. The current is steplessly adjustable and controllable, ensuring high reliability and low failure rate.
This machine is mainly used in the oral cavity repair room, and is a necessary equipment for surface polishing of various dental castings. This machine is equipped with two electrolytic cells that can be taken out for brushing, and two positive electrodes that can be used at the same time to improve work efficiency. Its hanging tools are convenient and practical, and the electrolytic tank can be taken out for brushing.

2.Key Advantages
①The output voltage of the machine is stable, the control is within the optimal range, and the current distribution is uniform, effectively avoiding excessive electrolysis (influence on workpiece size).
②The electrolyte temperature rises slowly, which effectively protects the electrolyte, prolongs its service life and reduces its cost.
③The workpiece is fast and bright to improve efficiency.
④The current can be controlled to completely avoid frequent fuse burning and component burning caused by the rising current of traditional electrolytic machine.
⑤Precise potentiometer is used to adjust the current more accurately.
⑥With overload and overheating protection functions, the service life is longer.

3.Specifications
①Power supply: 220V
②Time range: 0-999min
③Rated power: 250W
④Electrolyser capacity: 800ml*2
⑤DC output current: 0-20A
⑥Overall volume: 350*280*250mm
⑦Weight: 13kg

4.Operation Steps
①Pour the electrolyte into the electrolytic cell and fix the electrolytic tile (cathode) against both ends of the electrolytic cell.
②Clamp the bracket (workpiece) with a clamp (anode), hang the workpiece with copper wire, and put it into the electrolyte. Be careful not to contact the electrolytic pad.
③Set the working time and adjust the current. The working time and current can be adjusted appropriately according to the size of the workpiece and the new and old degree of the electrolyte. It is recommended to use a large current to quickly process the surface, and then reduce the current to increase the brightness of the mirror.
④After the set time is over, take out the support (workpiece) and clean it with water.
 
 
PushAuction