To get the best result from the nameset or badge supplied by 113 First Street, please follow the steps below carefully: • Set your iron or heat press to around 150°C • Place baking paper or heat-resistant paper over the nameset/badge before pressing • Apply firm, even pressure for around 15–20 seconds • Use a flat surface with slight cushioning, such as an ironing board or heat-press mat
Important – cooling stage After pressing, allow the transfer to cool down completely before removing the clear plastic film. This is a cold peel process only. Peeling while hot or warm may prevent the adhesive from bonding properly and could cause lifting.
Using a household iron If you are using a home iron instead of a heat press, please be extra careful with temperature control. Household irons often require more time and may need several slower presses to achieve a secure result.
⸻
Size & Pre-Purchase Check
At 113 First Street, I always try to show the actual size and proportions clearly within the listing photos for reference. If anything is unclear, you’re very welcome to message me before purchasing to confirm. As size guidance is already provided, returns requested after purchase due to size expectations unfortunately cannot be accepted.