Keep Molotow 30ml bottles organised, visible and easy to reach with this compact two-tier holder designed for SKÅDIS pegboards.
Each holder stores 10 bottles in an angled layout, helping make efficient use of vertical pegboard space while keeping paints easy to identify and remove.
The lower 5-bottle section fixes directly to the SKÅDIS board. The upper 5-bottle section then slots into the lower section to create the complete 10-bottle holder.
Features:
* Holds 10 bottles * Compatible with Molotow 30ml bottles * Designed around bottles approximately 21.6mm in diameter * Angled storage for clear visibility and easy access * Two-tier design to maximise pegboard space * Lower section fixes directly to the SKÅDIS board * Upper section slots into the lower section * Helps keep paints off the work surface * Suitable for hobby paints, inks and other bottles of compatible dimensions * 3D printed in PLA+
Fitting note: The upper section slots securely into the lower section. If preferred, a small amount of glue can be added at the join for a more permanent fit.
Please check your bottle dimensions before ordering. Bottle sizes can vary between manufacturers and ranges, so compatibility with bottles outside the stated dimensions cannot be guaranteed.
Paint bottles and SKÅDIS pegboard shown are for demonstration purposes only and are not included.
This item is 3D printed in PLA+, a bio-based plastic commonly made from renewable feedstocks such as corn starch or sugarcane, reducing reliance on fossil-based plastics. Each item is printed using quality-focused settings selected to suit the model, with fine or adaptive layer heights used where appropriate to achieve good surface detail. As an FDM 3D-printed product, minor layer lines may be visible and are a normal part of the manufacturing process.