Fits the tall-chassis Intel NUC7 kits, the ones with room for a 2.5" drive, in a 19" rack at 2U. Front-mounted so the power button, the headphone jack and the front USB ports all stay reachable without pulling the NUC out.

CONFIGURATIONS

• 1x: one NUC on the panel, paired with a blank half that fills the rest of the rack width.
• 2x: two NUCs side by side in the same 2U.

FITS

• Intel NUC Kit NUC7i3BNH
• Intel NUC Kit NUC7i5BNH
• Intel NUC Kit NUC7i7BNH
• The Optane and special order versions of the same kits: NUC7i3BNHX1, NUC7i5BNHX1, NUC7i7BNHX1, NUC7i3BNHXF, NUC7i5BNHXF and NUC7i7BNHXG

All of these use the same Baby Canyon tall chassis, so one mount covers them.

⚠️ Before you order:

• Check that your label ends in BNH. The NUC7i3BNK, NUC7i5BNK and NUC7i7BNK are the slim kits with no 2.5" drive bay. They are a shorter chassis and will not seat in this one.

WHAT YOU GET

• The printed mount pieces for the configuration you pick, plus the hardware that joins them at the seam.
• Rack screws are not included. Use whatever your rack takes.

MODULAR
This is part of my Modular Series. The 1x arrives with a blank half already, so it fills the full rack row the day it lands. That blank swaps for any other 2U Modular Series mount in my shop later, so you can put a second device in the same row. Pieces pair within the same U height, so a 2U joins a 2U.

MATERIAL
3D printed in PETG, not PLA. An i7 NUC sitting in a closed rack runs warm, and PETG holds its shape where PLA starts to soften.

A 10" mini rack version of this mount is also listed in my shop, along with a 3U version that holds four. 💬 For any custom design requests please message me.