eBay

6" Offset Rally Stripes Set Dodge Durango SXT/GT/Citadel/SRT/Hellcat Models

High quality KK vinyl
A complete set of 3 Stripes
Each stripe is 6″inch wide
You will get enough for the Hood, Roof, Trunk & Bumpers
Very easy to trim, fit, and install – Does NOT come with Scoops Cut Out as they are intended for any model

They are made with automotive grade KK Vinyls Comes as a Set of 3 stripes, you will get enough to do the hood, front bumper, roof, rear bumper and trunk of your car.

Comes covered in clear application transfer tape which is removed after application, some trimming is needed to fit these to your car but its super easy.
This premium quality KK vinyl is durable and long lasting under any weather situation. It can be adhesive and remove to any surface easily and will last for 6-8 years.

Installation Tips:
The top layer of the decal stripe is the application transfer tape (transparent film). The middle layer is the vinyl decal. The adhesive side of the vinyl faces downward. The bottom layer is the backing paper.
Decal Preparation Before Installation - Unroll the decals on a clean flat surface and allow them to stretch out to it's original shape in a few hours. There will be bubbles or creases on the clear transfer film, but it does not matter for installation just because they were packed in roll.
The decals can be install using Wed or Dry method. The wet application method applies a vinyl graphic to a substrate by using a fluid to assist with positioning. The dry method does not use fluid but rather depends on the skill of the installer to correctly position the film.