Fits the Geekom IT15 in a 10" mini rack at 2U, with the ports and power button reachable and the side vents left clear.

FITS

• Geekom IT15, both the Core Ultra 9 285H and Core Ultra 5 255H configurations

These share the same chassis, so one mount covers either.

⚠️ Before you install: take the four rubber feet off the bottom of the IT15. The mount is sized to the bare chassis for a snug fit.

WHAT YOU GET

• One 3D printed mount, holding the IT15 in a single 10" wide bay.
• Rack screws are not included. Use whatever your rack takes.

MATERIAL

PETG, not PLA. A Core Ultra 9 under load puts out real heat, and PETG holds its shape where PLA would soften.

A 19" version of this mount is also listed in my shop. 💬 For any custom design requests please message me.