FiiO DP11 HiFi Desktop CD Digital Transport Player, CS43198 DAC, Full Digital & Analog Outputs, CD Ripping MQA

FiiO improved the DP11’s disc-reading system and considerably reduced the device’s noise, enabling quiet operation.
The CD player can also connect to an external DAC through its AES, optical, and coaxial outputs.

To further improve the DP11’s performance, the manufacturer equipped it with two power inputs: one that uses its internal power supply
and another that allows connection to an external linear power supply. Full details of this new FiiO release are provided below.

The DP11’s custom disc-reading mechanism
FiiO equipped the DP11 with a disc-reading mechanism designed specifically for desktop devices.
The manufacturer optimized the servo-control software to improve CD-reading accuracy and capability.
According to the company, future updates may further enhance the capabilities of its desktop CD player.

A wide range of outputs for connecting the DP11
To provide greater flexibility when connecting the DP11 to other audio equipment, FiiO included coaxial, optical, and AES outputs.
This allows the CD player to connect to DACs even when some of their digital inputs are already occupied.

In addition to its digital outputs, the DP11 has an analog RCA output for connection to active speakers or amplifiers.
This functionality is enabled by a built-in Cirrus Logic CS43198 DAC.

USB digital interface functionality
The DP11 features a USB mode to expand its connection options with computers, tablets, and smartphones.
This function allows digital audio signals to be routed to the coaxial, optical, and AES outputs. Alternatively,
the RCA output can transmit analog signals to an active speaker or an amplifier.

Note that the side USB port must be used to update the DP11’s firmware. The rear USB port is used exclusively for ripping CDs.

How to extract music from CDs with the FiiO DP11 CDs can be ripped using the USB-C port on the rear of the FiiO DP11.
This requires a USB-C flash drive with a capacity of 32 GB or less, formatted as FAT32.
Tracks are extracted in WAV format and saved directly to the flash drive as the CD is read.

Isolated digital outputs and femtosecond crystal oscillators
To improve digital signal transmission quality, the DP11 features transformer-isolated coaxial and AES outputs.
Two femtosecond crystal oscillators are also used to reduce jitter [1].
[1] Jitter is the unwanted variation in the timing at which the DAC reads an audio sample. Ideally,
digital audio samples should be read and converted at perfectly regular intervals.

Separate power supply circuits for each DP11 section
To provide a quieter background, greater perceived detail, and better separation of sounds, each section of the DP11 has an
independent power supply circuit. FiiO separated the power supplies for the CD servo mechanism, digital circuits, and analog
circuits. These three sections also occupy physically separate areas on the DP11’s printed circuit board (PCB).

Infrared remote control for greater convenience
An infrared remote control is included with the FiiO DP11.

Specifications
General parameters
• CD ripping (music extraction): Supported
• Colors: Black/silver
• DAC chip: Cirrus Logic CS43198
• Dimensions: 213 × 230 × 67 mm
• Disc-reading mechanism: Custom
• Display: 3.71-inch LCD
• Main microcontroller (MCU): GigaDevice GD32F305RET6
• Operating modes: CD playback, USB DAC
• Optical pickup: Custom
• Remote control support: Compatible only with the included remote control
• SACD support: Not supported
• Volume control: None
• Weight: 1,802 g (1.8 kg)

Buttons and connections

• Analog line outputs: RCA connectors.
• Digital outputs: Coaxial (RCA), optical (standard TOSLINK), and AES (three-pin XLR).
• Physical buttons: Power on/off, open/close tray, stop playback, mode selection, playback order selection, play/pause, previous track, and next track.
• USB ports: One USB port for CD ripping and one USB port for firmware updates

Power supply

• AC: 100–240 V, 50/60 Hz
• DC: 12 V / ≥ 2 A

General audio parameters

• Maximum sampling rate at the AES output: Up to 192 kHz / 24 bits
• Maximum sampling rate at the coaxial output: Up to 192 kHz / 24 bits
• Maximum sampling rate at the optical output: Up to 96 kHz / 24 bits
• Maximum sampling rate in USB DAC mode: Up to 384 kHz / 32 bits; native DSD256

RCA single-ended (SE) line output (LO) parameters

• Total harmonic distortion plus noise (THD+N) – UAC: < 0.00068% (1 kHz / 0 dB, with a 10 kΩ load)
• Total harmonic distortion plus noise (THD+N) – CD: < 0.0014% (1 kHz / 0 dB, with a 10 kΩ load)
• Noise floor: < 8.1 µV (A-weighted)
• Signal-to-noise ratio: ≥ 109 dB (A-weighted)
• Channel separation: ≥ 104 dB
• Dynamic range: ≥ 109 dB (A-weighted)
• Line output level: 2.2 Vrms (1 kHz, with a 10 kΩ load)
• Frequency response – UAC: 20 Hz–90 kHz; attenuation < 1.7 dB
• Frequency response – UAC: 20 Hz–20 kHz; attenuation < 0.1 dB
• Frequency response – CD: 20 Hz–20 kHz; attenuation < 1.3 dB

Payment Terms
 
1.We accept PayPal only.
2.All major credit cards are accepted through secure payment processor PayPal.
3.Payment must be received within 7 business days of auction closing.
4.We ship to your eBay or Paypal address. Please make sure your eBay and Paypal address is correct before you pay.
Shipping Terms
 
- For remote regions, we will charge your extra shipping costs. Usually it cost about 35USD-50USD. We will contact you after your payment. Thanks for your understanding.
Return Terms
 
1. If you receive defective item, please kindly notify us within 14 days. We will guide you the returning instruction for replacement or refund.
2. If you purchased in improper condition, please NOTE that the sipping and handling fee will not be refund, all return shipping fee should paid by the buyer unless item DOA.
3. We reserve the right to refuse any returns for objective reasons.
Custom Duties & Taxes
 
1. Import duties, taxes, and charges are not included in the item price or postage cost. These charges are the buyer's responsibility.
2. Avoiding some unnecessary trouble, please check with your country's customs office to inform us what we should declare its value before shipping.
Feedback
 

1. If you are dissatisfied for any reason, please don't be quick to leave us neutral or negative feedback. We work hard to make sure EVERY CUSTOMER 100% SATISFIED and resolve any problem for you and always leave positive feedback to all our customers.
2. If you are satisfied with the product you received, please kindly leave us a positive feedback and 5 star DSR. If there is any problem of your order, please feel free to contact us firstly, we are responsible and credible seller, will follow it for you asap.