| Output | output voltage | 0V to input voltage | |
| Output frequency |
Low frequcncy mode:0.00Hz-320.00Hz High frequcncy mode:0.0Hz~3200.0Hz |
||
| Camier frequcncy | 0.8Hz to 16.0kHz(adjustable based on the load) | ||
| Overload capacity | 150%/1min | ||
| Input | Rated voltage/frequcncy | Single-phase:220V,50/60Hz | |
| Voltage fluctuation range | Single-phase: 220V415%Allowable range:AC 187V-253V | ||
| Frequency fluctuation range | ±5% | ||
| Control Performance | et frequcncy resolution | Digital setting | 0.01Hz |
| Analog setting | Maximurm frequcncy ×0.025% | ||
| Control mode | VF control, sensorless vector control (svc) | ||
| Starting torquc | svc | 0.25HZ/150% rated torquc | |
| Spced control range | svc | 1:200 | |
| Steady-state velocity accuracy | svc | Maximum speol±0.5% | |
| Torque lift | Torque lift 0.0% to 30.0% | ||
| V/F curve | Linear，multi-point,V/F complete scparation and V/F semi-separation | ||
| Cycle-by-cycle current limit | Fast resporse and normal opcration in the V/F mode | ||
|
Accelcration and deceleration curve |
Linear or S-curve accclereation and deceleration; 4 kinds ofacceleration and deceleration time,0.1s to 6,500.0s | ||
| Automnatic voltsge rcgulatioa | Autormatically maintain the coastant output voltage in case of changes in grid voltage | ||
| DCbraking |
DCbraking frequtncy:0.00 Hz~Maximumn frequency DCbraking current:0~100.0% DCbraking time:0.0s-100.0s |
||
| Jog control |
Jog frequcncy range:0.00Hz~Maximum froqucpcy Jog acceleration and deceleration time 0.1%-65000s |
||
| PLC and multi-speed | Built-in PLC function, supporting 16 speeds at most | ||
| overvoltage/overcurrent stall control | Automatic limit of running curcnt and voltage to prevent frequcnl tripping | ||
| Torque limit and control | Automatic limit of torque current,for torque control in vector control mode | ||
| Control input | Running command | operation panel.control terminal and serial communication setting, for switching of multiple modes | |
| Primary frequency command | Digital setting，analog voltage setting,analog current setting.pulse setting and communication setting, for switching of multiple modes | ||
| Auxiliary frequency command | Combined with the primary frequency for fine tuning and synthcsis of frequcncy | ||
| Output signal | Input terminal |
Keyboard potentiomcter input,0-5V 5 programmable input terminals，with one supporting high speed pulse input up to 50 KHZ One AI terminal supporting 0-10 V voltage input |
|
| Output terminal |
One high speed pulse output terminal(or programmable open collector output) One programmable relay output Two AO outputs, one supporting 0-10V voltage output and the other supporting o-20mA or4-20mA current output |
||
| Serial communication port | RS-485 port | ||
| Protection function | Overvoltage,undervoltage,overcurrent,current limiting,overload,overheat, electronic thermal overload relay, overvoltage stall, data protection,etc. | ||
| Display |
5-digitdigital display (LED) and status indicator |
Parameter setting:Display the parameter number and value | Function code, data,status |
|
Runningdisplay:running frequcncy, current, ctc. |
|||
| Fault display: fault code | |||