1.1 Heater designed for heating composite resin material, improve the flow of its adhesive properties; At the same time it can also be used to heat adhesive when used manual equipment.
Heater use the precision circuit control module to heat, control the temperature tolerance within 1 degree, According to your choice of material and it can set any integer temperature within 40-70℃
1.2 Some materials and recommended temperature
Operation:
2.1 After plug the power supply, the digital tube is always on ” -- ℃ ”
2.2 After plug the power supply, single press “ ON/OFF/SET ”
Heater goes into the heating state according to the set temperature at previous power-off
.It automatically stops heating after reaching preset temperature.
2.3 After plug the power supply, single press “ + ” or “ - ” into the setup mode. Press “ + ” can increase the preset temperature. Press “ - ” can decrease the preset temperature. After setting, single press “ ON/OFF/SET ” into the heating state. It automatically stops heating after reaching preset temperature.
Notice:
In the setting mode, long press the “+”or “-” to quickly increase or decrease the preset temperature, any integer within the preset temperature 40-70 can be selected.
Technical parameter:
3.1 Power adapter:
Input:AC100-240V 50/60Hz
Output:DC15V2A
3.2 Heating temperature range:40℃-70℃，±1℃
1 * AR Heater
1 * Plug
1 * User Manual
FDA Statement:
The sale of this item may be subject to regulation by the U.S. Food and Drug Administration and state and local regulatory agencies. If so, do not bid on this item unless you are an authorized purchaser. If the item is subject to FDA regulation, I will verify your status as an authorized purchaser of this item before shipping of the item.
Seller's name:xierong-74
City State: Beijing
Phone number:17340823601