Outer Rocker Panel In Weld-Thru Primer Driver Side Mustang 67-70

Highlights

• Increased Structural Support
• Weld-Thru Primer Finish
• Heavy Gauge Steel
• Driver Side Specific

CJ Classics Driver Side Outer Rocker Panel in Weld-Thru Primer for all 1967, 1968, 1969, and 1970 Mustangs.

If you are restoring a 1967-1970 Mustang that has extensive structural damage, you will most likely need full outer rocker panels. Get what you need with this CJ Classics Driver Side Outer Rocker Panel In Weld-Thru Primer (3647MDWT) from CJ Pony Parts!

Features and Benefits:
- Heavy gauge steel
- Weld-thru primer finish
- Measures 63" long
- Driver side specific
- Increases structural support

CJ Classics' full-length outer rocker panel is 63" long and will provide a much more application specific fit over the basic 1965-1970 outer rocker panels. The high-quality outer rocker panel offers increased structural support due to the higher gauge of steel and features a weld-thru primer finish.  The rocker panel is located underneath the door and runs from the front of the rear wheelhouse to the rear of the front fender. This panel (3647MDWT) is specific to the driver side of your Mustang.

Advantages of Weld-Thru Primer:
- Reduces prep time when welding new parts to new parts that are both covered in the weld thru primer
- Reduced spatter
- Lower distortion of the panels
- Superior conductive properties that help minimize high heat zone problems
- Eliminates corrosion that would form between overlapped panels or multi-layered spot welds
- Helps when welding a new panel to old metal
- Lower resistance at the weld surface allows better penetration into the denser, new steel that helps forgive an old alloy's problems with porosity and impurities
- Helps prevent resin build up between welds that can trap moisture in the old porous steel that leads to failure at the weld borders

Vehicle Fitment:
- 1967-1970 Mustang