Dewalt DCW600 Edge Banding Trim Attachment via DNP612 Plunge Base

The worst part of edge banding is always to shave off the extra without damaging the edge banding or the wood/melamine i'm working with. I have tried several options but none gave met finish and confidence i was looking for

About this item

• This is a one piece solution which gives a very accurate result
• Has a large surface area to hold the router level on the workpiece
• Large surface ensures that the fingers stay well clear of the spinning router bit
• The large surface area ensures good level contact with the piece that needs to be trimmed to
• Large opening ensures that not only thin laminates can be trimmed but also solid oak edge banding (up to 30mm thick)
• It will fit to the Dewalt DCW600 via its DNP612 Plunge Base with the factory screws(4x)
• Designed by PLAWorkshop exclusively for SAS
• Build in the UK
• Colour may vary
• Quesiton please ask

Any issues with ordering, drop me a message.