Features:

Built to strict quality control standards 100% factory tested.

Consistent starting power with a high quality solenoid that properly engages the starter drive with the flywheel in your vehicle every time the ignition key is turned.

High standards for components like wiring, brushes, insulation, bearings and coatings for consistent performance in all environmental conditions.

High performance machining of the starter casing for ease of installation and solid joining of the starter housing and your vehicle's mounting surfaces

Specifications:

Material:Aluminum

Color:Silver

Placement on Vehicle:Front

Voltage:12

Rotation:CW

Teeth:10

Power Rating:1.0 KW

Starter Type:PMGR

Part Numbers:

GM: 19317693
Nissan, Infiniti: 23300-CK800, 23300-EN200, 23300-EN200R, 23300-EN20A, 23300-EN20B, 23300-EN20D, 23300-EN21ARE, 2330M-EN21ARW, 23300-EN20C, 23300-EN20E, 2330M-EN22ARW, 23300-EN22B, 23300-EN22BRE, 2330M-EN22BRW, 23300-EN22C, 23300-EN22A, 23300-EN22ARE
Renault: 7701065384, 8201268221
Hitachi: HST-114902BSH, HST-114922, S114-902, S114-902A, S114-902B, S114-902BSH, S114-902C, S114-902E, S114-902R, S114-922, S114-955, S114-955A, S114-955C, S114-955D, S114-955B
Marelli: 063280082010
Lester: 17982, 17449, 19295, 19266
Arrowhead: SHI0166
BBB Ind: 17982
Bosch Remanufactured: SR2300X
Carquest: 17982S
TYC: 1-17982
Remy Remanufactured: 16080
J & N Automotive: 410-44067
MPA: 17982
NAPA: 244-8548
Wilson: 91-25-1192
Dixie Electric: S-80300
Excel: 21529
Hitachi Reman: STR0021
Andre Niermann: 014902

Fitment:
Chevrolet City Express 2015-2018 L4 2.0L

Nissan Cube 2009-2010 L4 1.8L

Nissan Cube 2011-2014 L4 1.8L Fits Exc. Calif., From 12/2012 or Exc. Calif., To 12/2012

Nissan Juke 2011-2017 L4 1.6L

Nissan NV200 2013-2021 L4 2.0L Fits To 05/2016 or From 05/2016

Nissan Sentra 2016-2019 L4 1.6L Fits To 12/2015 or From 12/2015

Nissan Sentra 2013-2019 L4 1.8L Fits To 12/2015 or From 12/2015

Nissan Sentra 2007-2008 L4 2.0L

Nissan Sentra 2009-2012 L4 2.0L Fits To 9/2008 or From 9/2008, Exc Calif.

Nissan Versa 2007-2012 L4 1.8L Fits S Model or SL Model To 09/2009

Nissan Versa 2007-2012 L4 1.8L Fits SL Model From 09/2009

Package include:
1 x Starter

Attention:

How to Install a Car Starter?

1. Disconnect the battery.

2. Jack up the vehicle if need be.

3. Locate the starter.

4. Disconnect the wiring to the solenoid.

5. Remove the starter retaining bolts then the starter.

6. Compare the new starter to the old one.  Slide the starter into place.

7. Insert the starter retainer bolts.

8. Connect the wiring to the starter solenoid.

9. Reconnect the battery.

10. Listen to the vehicle as you attempt to start it.

11. Ensure the battery terminals are clean and secure.Charge your vehicle’s battery.

12. Check to see the starter solenoid is bad.

Note:

Starter Fault Check:

The starter often has failures and phenomena that cannot rotate or rotate slowly. In this case, check the following aspects:

1. The battery has no electricity or the electricity is weak, so the starter cannot rotate or rotate slowly.

2. The starter thread is loose or off, and the switch or adsorption switch fails.

3. The brush is worn out or the brush surface is not correct, and the spring is weak, resulting in poor contact of the rectifier.

4. Excitation coil or armature coil is short-circuited or disconnected.

5. The rectifier is fouled and the mica sheet is protruding, causing poor contact between the brush and the rectifier.