GOTEK System Floppy to USB EmulatorIMPORTANT TIPSThe default loaded firmware is from the GOTEK manufacturer, support 1.44M, 34pin - IBM/PC interface, the format is DOS/FAT12, and the chip is AT32F415 Cortex-M4.Please make sure your machine could support these important points.Attention in InstallationDo not be reverse when installing the cable;The USB drive must be formatted into 1.44M FAT12 format , then it could be identified by our GOTEK emulator.If you would like to use our Gotek floopy emulator on AMIGA, please change our default firmware to FlashFloppy firmware first.Features:* 32-bit CPU designed, high integration, and reliable performance.* Connected to the device via the floppy drive interface, simple to install and use.* Use ordinary USB flash drive for data storage, instead of the floppy disk.* Suitable for all kinds of textiles, electronics, machinery which use floppy disk and driver.GOTEK system Floppy to USB emulatorModel: SFR1M44-U100 code*: U00Suitable Machines:Machines use normal 1.44MB floppy disk an driver, example : STOLL flat knitting machine, MULLER3 BONAS STAUBLI JC4 JC5 label weaving machine, YAMAHA KORG etc music instruments which use normal 1.44MB floppy disk and driver.Floppy driver with below function needed:Floppy driver with 34pin interface, and 5V DC power plugUse 2HD flpppy disk with 1.44MB capacityFormat of disk : Cylinders: 80 Tracks: 160 Sectors/Track: 18Bytes/Sector: 512 Data transfer rate: 500 kbpsEncoding method: MFM.Features:1.34pin floppy driver interface, 5V DC power supply, easy to install.2.Use ordinery usb flash drive as the medium for transfer design.3.1000pcs partitions in usb flash drive can be used.4.Built-in self-format function. (read relevant documents to use this function)Panel:8segment numbers: represent partitions numberGreen led: status of read and write operationUSB port: connect usb flash driveButton Function:Left button used to rise ten-digit, right botton used to rise single-digit, press 2 button together to rise hundred-digit.