• Description:
  • For LS SWAP 4.8 5.3 6.0L 97-06 Drive by Cable DBC LS1 4L60E Stand Alone Harness

    Description:

    • 100% Brand New
    • An easy to install design
    • These harnesses are designed for '97 - '06 Vortec retrofits into older muscle cars and street rods or newer non-emissions controlled vehicles.
    • They are completely plug and play with switched power, constant power and ground connections required.
    • Harnesses allow for installing the PCM underneath the dash of your vehicle with a sliding grommet seal for that professional leak proof look.
    • 1. This LS1 standalone harnesses are designed for installing these new GM EFI engines into your ride, whatever it may be.
    • 2. Compatible with LS1 4L60E 2003-2006 for Chevrolet/GMC/Cadillac/Hummer engine; suitable for 03-06 all using 4L60E(Vortec engine 4.8 5.3 6.0) transmission.
    • 3. This harness is a 3 wire MAF and a 1 wire alternator. For drive by cable throttle body Only.
    • Note: That harnesses are for non-emissions equipped vehicles and do not include air pump or EGR provisions

     

    Connections Included in this Standalone Harness:

    • Throttle Position Sensor
    • Idle Air Control Valve
    • Coolant Temperature Sensor
    • Alternator/Generator
    • All 8 Injectors with EV1 Injector Connectors
    • Bank 1 Coil Harness Connector
    • Bank 2 Coil Harness Connector
    • Knock Sensor Harness Connector
    • Camshaft Position Sensor
    • 4L60e Transmission
    • Speed Sensor
    • Bank 1 Upstream Oxygen Sensor
    • Bank 2 Upstream Oxygen Sensor
    • Mass Air Flow
    • IAT (Only If using a 3 Wire MAF)
    • Crank Position Sensor
    • A/C Pressure Sensor
    • OBD II Port (DLC Port)
    • Single Harness Ground
    • Single Battery Constant Connection

     
    Connections From Our Harness You Will Need to Hookup:

    • Fuel Pump (Required)
    • Switched Ignition (Required)
    • TCC Brake Switch (Converter Control – Required)
    • Malfunction Indicator (Check Engine, MIL, CEL, ETC.)
    • Speedometer
    • Tachometer
    • Fan 1 Relay Control (Low Speed or Single Control)
    • Fan 2 Relay Control (High Speed or Second Fan Control)

     

    Fitment:

    For 1999-2006 Drive By Cable LS1 Engines
    For 1999-2002 Camaro/Firebird

    For 1999-2004 Corvette (DBC ONLY)

    For 2004 GTO

    For 2003-2006 CTSV

     

    Package Included:
    1× Standalone  wire harness for LS1 4L60E

    W/O Product Instruction

     

    Notes:

    Accessories: You will get exactly as shown in the picture.

    Hi-performance aftermarket parts; no instruction included; professional installation is suggested.

    For any needs please contact us via eBay message.

     


    Item Specifics
    Country of Origin United States
    Brand Unbranded
    Manufacturer Part Number RUS1271592
    Type Standalone Wiring Harness
    OE/OEM Part Number LS1-4L60E
    Fitment Type Direct Replacement
    Material Rubber/Metal/Plastic
    Surface Finish Black
    Manufacturer Warranty 1 Year
    Features Drive by cable(DBC), Direct Fit, Easy Installation
    Items Included 1× Complete for 4L60E wire harness
    Modified Item No
    Instruction Manual Included No
    Custom Bundle No
    Note Professional installation is always recommended!!!

    Payment

    We accept Paypal,Google Pay,VISA,Master Card,American Express,Discover,eBay Mastercard payment.

    Shipping

    Pickup is not available as all items are shipped to buyers - NO EXCEPTIONS
    Orders ARE POSTED BY USPS OR FEDEX.

     

    Returns

    If you are unhappy with your purchase for any reason, US buyers can return it to us in an un-used condition in the original packaging within 30 days of purchase and we'll give you a refund or exchange. The refund/Exchange will not include postage/eBay costs. Please note you MUST contact us to obtain a Return Authorization Number before returning any part. Any parcel without the Return Authorization Number will be rejected.

    If your item is faulty or was incorrect, you must contact our sales representative before returning the parcel and we will endeavour to solve the problem effectively. Video or picture is required to show the item condition before we issue the Return Authorization Number.

    Important Notice:
    1. Any returned item(s) without Return authorization number will be rejected.
    2. Please return your item(s) in original packaging and ensure that all packages are securely wrapped.
    3. We will not accept responsibility for loss or damage of goods during transit, please ensure that the insurance cover option is taken where possible.

    Feedback

    If you have purchased the wrong Good or are returning a Good as a warranty claim, we will accept a return of that good and issue refund or send out a replacement Good subject to the following:you must contact us first about the Goods before returning the Goods to us, and if we agree to accept a return of the incorrectly purchased Good or if we agree to accept the warranty claim over the Good then you MUST do the following:the Goods must be securely and appropriately packed so they are not damaged during transit;the Goods must be returned in their original packaging;the Goods must be like new and not show any signs of use or having been installed or fitted;The claim for refund must be advised to us no later than 30 days after the date you bought the Good.

    About Us

    ● High Quality
    ● Customer - Service
    ● Affordable Prices

    For LS SWAP 4.8 5.3 6.0L 97-06 Drive by Cable DBC LS1 4L60E Stand Alone Harness

    Description:

    • 100% Brand New
    • An easy to install design
    • These harnesses are designed for '97 - '06 Vortec retrofits into older muscle cars and street rods or newer non-emissions controlled vehicles.
    • They are completely plug and play with switched power, constant power and ground connections required.
    • Harnesses allow for installing the PCM underneath the dash of your vehicle with a sliding grommet seal for that professional leak proof look.
    • 1. This LS1 standalone harnesses are designed for installing these new GM EFI engines into your ride, whatever it may be.
    • 2. Compatible with LS1 4L60E 2003-2006 for Chevrolet/GMC/Cadillac/Hummer engine; suitable for 03-06 all using 4L60E(Vortec engine 4.8 5.3 6.0) transmission.
    • 3. This harness is a 3 wire MAF and a 1 wire alternator. For drive by cable throttle body Only.
    • Note: That harnesses are for non-emissions equipped vehicles and do not include air pump or EGR provisions

     

    Connections Included in this Standalone Harness:

    • Throttle Position Sensor
    • Idle Air Control Valve
    • Coolant Temperature Sensor
    • Alternator/Generator
    • All 8 Injectors with EV1 Injector Connectors
    • Bank 1 Coil Harness Connector
    • Bank 2 Coil Harness Connector
    • Knock Sensor Harness Connector
    • Camshaft Position Sensor
    • 4L60e Transmission
    • Speed Sensor
    • Bank 1 Upstream Oxygen Sensor
    • Bank 2 Upstream Oxygen Sensor
    • Mass Air Flow
    • IAT (Only If using a 3 Wire MAF)
    • Crank Position Sensor
    • A/C Pressure Sensor
    • OBD II Port (DLC Port)
    • Single Harness Ground
    • Single Battery Constant Connection

     
    Connections From Our Harness You Will Need to Hookup:

    • Fuel Pump (Required)
    • Switched Ignition (Required)
    • TCC Brake Switch (Converter Control – Required)
    • Malfunction Indicator (Check Engine, MIL, CEL, ETC.)
    • Speedometer
    • Tachometer
    • Fan 1 Relay Control (Low Speed or Single Control)
    • Fan 2 Relay Control (High Speed or Second Fan Control)

     

    Fitment:

    For 1999-2006 Drive By Cable LS1 Engines
    For 1999-2002 Camaro/Firebird

    For 1999-2004 Corvette (DBC ONLY)

    For 2004 GTO

    For 2003-2006 CTSV

     

    Package Included:
    1× Standalone  wire harness for LS1 4L60E

    W/O Product Instruction

     

    Notes:

    Accessories: You will get exactly as shown in the picture.

    Hi-performance aftermarket parts; no instruction included; professional installation is suggested.

    For any needs please contact us via eBay message.

     

    Item Specifics
    Country of Origin :United States
    Brand :Unbranded
    Manufacturer Part Number :RUS1271592
    Type :Standalone Wiring Harness
    OE/OEM Part Number :LS1-4L60E
    Fitment Type :Direct Replacement
    Material :Rubber/Metal/Plastic
    Surface Finish :Black
    Manufacturer Warranty :1 Year
    Features :Drive by cable(DBC), Direct Fit, Easy Installation
    Items Included :1× Complete for 4L60E wire harness
    Modified Item :No
    Instruction Manual Included :No
    Custom Bundle :No
    Note :Professional installation is always recommended!!!


    We accept Paypal,Google Pay,VISA,Master Card,American Express,Discover,eBay Mastercard payment.

    Pickup is not available as all items are shipped to buyers - NO EXCEPTIONS
    Orders ARE POSTED BY USPS OR FEDEX.

     

    If you are unhappy with your purchase for any reason, US buyers can return it to us in an un-used condition in the original packaging within 30 days of purchase and we'll give you a refund or exchange. The refund/Exchange will not include postage/eBay costs. Please note you MUST contact us to obtain a Return Authorization Number before returning any part. Any parcel without the Return Authorization Number will be rejected.

    If your item is faulty or was incorrect, you must contact our sales representative before returning the parcel and we will endeavour to solve the problem effectively. Video or picture is required to show the item condition before we issue the Return Authorization Number.

    Important Notice:
    1. Any returned item(s) without Return authorization number will be rejected.
    2. Please return your item(s) in original packaging and ensure that all packages are securely wrapped.
    3. We will not accept responsibility for loss or damage of goods during transit, please ensure that the insurance cover option is taken where possible.

    If you have purchased the wrong Good or are returning a Good as a warranty claim, we will accept a return of that good and issue refund or send out a replacement Good subject to the following:you must contact us first about the Goods before returning the Goods to us, and if we agree to accept a return of the incorrectly purchased Good or if we agree to accept the warranty claim over the Good then you MUST do the following:the Goods must be securely and appropriately packed so they are not damaged during transit;the Goods must be returned in their original packaging;the Goods must be like new and not show any signs of use or having been installed or fitted;The claim for refund must be advised to us no later than 30 days after the date you bought the Good.

    ● High Quality
    ● Customer - Service
    ● Affordable Prices


    All rights reserved.



    On May 8, 2026 at 22:04:27 PDT, seller added the following information:

    Datacaciques