• Strong and Durable: Made of #45 steel with a quenching process, it has high strength, good rigidity, and can resist wear, corrosion, and rust, ensuring a long service life.
• Complete Kit: This kit includes 18 bearing pullers, 3 tie rods, 1 multifunction disk, 1 top rod, 2 gaskets, and other accessories, making disassembly easier and allowing this kit to fit more bearings of different specifications. One set is sufficient for use.
• High Performance: The thickened and stiffened workpiece with high torque is hard and resistant to breakage, allowing large pulling forces to remove a wide range of tight and stuck bearings.
• Hassle-free Use: You can simply pull out the bearings manually by installing the kit in step-by-step correspondence. Even the novice can get started easily.
• A Good Assistant: This internal bearing puller kit with gaskets provides a professional, non-destructive, and easy way to remove bearings that will be your right-hand assistant.
• Multiple Sizes: The kit includes six bearing pullers with different sizes that can remove bearings of various shapes and sizes to meet your daily dismantling needs.
• Rounded Corners Design: The bearing pullers and tie rods have round corners rather than sharp ones, which can prevent your hands from being scratched.
• Practical ToolBox: The toolbox with suitable grooves allows you to well organize all accessories to avoid losing them. Meanwhile, the recessed handle on the top allows you to easily carry the toolbox.
• Application: It fits Kubota, Wade, and Yangma for the bearing disassembly of mechanical harvesters and can be used for vehicle maintenance, mechanical bearings, agricultural machinery, and so on.

• Color: Black, Silver
• Material: #45 Steel
• Surface Treatment: Quenching Process
• Puller Head: WE1/WE2/WE3/WE4/WE5/WE6
• Applicable Bearing: 6005/606/6007/6008/6009/6010/6205/6206/6207/6208/6209/6210/6305/6306/6307/6308/6309/6310

• Confirm the model of the removed bearing and select the corresponding puller head specification based on the bearing model.
• Assemble the pull horse head and the pull rod (Please note that all threads at the pull horse head end need to be screwed into the inner hole of the pull rod and locked tightly).
• Use a screwdriver to pry off the bearing cage to expose the ball, and pull the ball to leave gaps at three places at 120 °.
• Insert and rotate the puller head 90 ° at three gaps of 120 ° in order. At this time, the puller head can jam the inner and outer rings of the bearing, thereby confirming that the puller head model is correct.
• Install the multi-functional disk onto the pull rod, and secure the pull rod and the multi-functional disk with nuts. Before locking, continue to confirm that the puller head can fully jam the inner and outer rings of the bearing. If there is any misalignment, slightly rotate the pull rod for adjustment until the nut is fully locked.
• Hold the handle in hand and rotate the ejector pin to allow the tip to enter the center hole of the spindle head, continuing to rotate until the bearing is removed.

• 1x Bearing Puller Tool Set