Is your shifter base worn out too? Transform your driving experience with a complete Shifters short throw shifter!

This plastic bush is fitted at the bottom end of the gearstick over the end pivot ball. Made of a highly robust material and to tighter tolerances it is an upgrade over the original part. Fitted in place it reduces the amount of unwanted movement in the gearstick / shifting to a minimum.

Due to the location of this bushing it’s subjected to a large degree of force and movement which results in wear. Once this happens extra clearance is formed which directly translates into freeplay and hence less precise gear shifting. Even worse is that despite being a consumable part inexplicably there is no replacement available from any where else.

OE replacement plastic bushing cup for the shift control lever pivot ball on 4, 5, & 6 speed manual transmission shifters found in the following Datsun / Nissan REAR WHEEL DRIVE applications:

For 1975-1988 200SX

For 1989-1998 240SX

For 1972-1973 240Z

For 1974 260Z

For 1975-1978 280Z

For 1979-1983 280ZX - non-turbo only

For 1984-1989 300ZX - non-turbo only
Does NOT FIT turbo models or newer models

For 1974-1979 620 pickup - 4 spd only

For 1980 720 pickup - 4 speed only


For 1986-1997 D21 Hardbody pickup - I4 only
Does NOT FIT V6 models (20mm OD)

For 1998-2021 Frontier pickup - all

For 1987-1988 Pathfinder SUV - I4 only
Does NOT FIT V6 models (20mm OD)

For 2000-2004 Pathfinder SUV

For 2000-2015 Xterra SUV - all

Transmission models include F4W71 (B-on), FS5W71 (B-on), late FS5R30A & B (1998/2000-up trucks only), FS6R30A

Bushing has a 16mm outside diameter and fits onto a 12mm dia sphere (at bottom of shift lever)

WARNING: early FS5R30 use a 20mm OD bushing

If yours is loose or missing (!) you need one of these!

Simple Installation - remove shifter boots, remove snap ring inside housing, & lift out lever (no need to remove base)

📦 Package Include: 2PCS