About this item
Headlight bulb type: 9012
Kit includes: 2 x 9012 Halogen Bulbs.
Colour: White 6000K
Wattage: 55w
Voltage: 12v
Guarantee: 12 months
Use: Low Beam or high beam
These are Plug and Play Two Pin Bulbs.
Brand New Bulbs in Packaging.
E Marked & Fully Road Legal.
TUV Approved.
Headlight bulb type: 9012
Kit includes: 2 x 9012 Halogen Bulbs.
Colour: White 6000K
Wattage: 55w
Voltage: 12v
Guarantee: 12 months
Use: Low Beam or high beam
These are Plug and Play Two Pin Bulbs.
Brand New Bulbs in Packaging.
E Marked & Fully Road Legal.
TUV Approved.
Plug & play, simply remove your existing bulb & put this one in it's place. Note, if you have not installed 55w bulbs before then we do advise you replace your wiring loom prior to installing these 55w bulbs & increasing the wattage!
Note: When replacing your bulbs it is strongly advisable to leave the foam protective cover on the bulbs until they are properly installed. Moisture from your hands that is transferred to the bulbs will reduce the life span and quality of the output of the bulbs. We recommend wearing gloves when replacing your bulbs.
Important notice: The compatibility chart above is for guidance only. Bulb fitments vary and we advise you to check your existing bulb to ensure you are purchasing a direct replacement, this is because there are different types of bulb that fit your vehicle.
Packing Including:
2Pcs 9012/HIR2 Halogen Headlight Bulbs
Install Caution:
1. As a safety precaution, make sure that the car has had time to cool down properly
before starting the installation process.
2. Put the vehicle into park or make sure it is securely in gear.
3. Make sure to have the ignition turned off and the keys removed.
4. Be careful to avoid burns, especially when turning on or off the vehicles lighting.
5. Be careful to avoid crushing or cutting the bulbs. Also make sure to not touch the
bulbs with your fingers, as this will cause blotting.
6. Fully examine the connection of the contact points, ports and the wires as faulty
connections can cause lighting problems.
7. Make certain that the end of the bulb does not come in contact with the interior
1. As a safety precaution, make sure that the car has had time to cool down properly
before starting the installation process.
2. Put the vehicle into park or make sure it is securely in gear.
3. Make sure to have the ignition turned off and the keys removed.
4. Be careful to avoid burns, especially when turning on or off the vehicles lighting.
5. Be careful to avoid crushing or cutting the bulbs. Also make sure to not touch the
bulbs with your fingers, as this will cause blotting.
6. Fully examine the connection of the contact points, ports and the wires as faulty
connections can cause lighting problems.
7. Make certain that the end of the bulb does not come in contact with the interior