|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Fits:
2016-2019 HONDA CIVIC
Features:
Easy Installation
High flow design provides long lasting, efficient cooling
Factory lubricated for long life
Precision ground shaft and hub accept fan clutches perfectly
Quality forged housing is specially formed to ensure maximum coolant flow
Precision built and balanced - Pressed on impeller increases water flow
Unitized seal protects bearings - Provides long life and leak free performance
The radiator cooling fan is an integral part of your car that is responsible for cooling the radiator of your car. The radiator cooling fan does this by either pulling or pushing air into the radiator keeping the radiator temperatures within the safe levels. A damaged radiator cooling fan is a determining factor in preventing your car from overheating. Below are the materials that you need along with the instructions on how to replace a radiator cooling fan.
Note:
It is recommended to replace your Radiator Fan Clutch & Water Pump at the same time. The two parts age at the same rate so if one has failed, the other is probably not far behind. The fan clutch and water pump are also connected by the same shaft. When one part fails it typically affects the operation of the other. To prevent premature failure of your new unit, it is wise to replace both at the same time.
Radiator Notes:
Specification:
Core Material: Aluminum
Tank Material: Plastic
Quantity: 1pcs Radiator
Warranty:1 Year limited
Direct Replacement
100% brand new radiator (as picture showed)
--------------------------------------------
? Installation guidelines provided in the box
? Premium OE hardware and fittings included in every box
? OE design to ensure exact fit, form and function for an easy drop-in installation
? Maximum cooling efficiency and perfect fit
? Leak-tested aftermarket radiator
? SO 9001 certified manufacturing plants
How to replace a new radiator?
1. Disconnect the battery.
2. Drain the radiator fluid into a suitable container.
3. Remove the old radiator:
-Take off any plastic covers around the radiator.
-Disconnect the electrical connector to the fan, and unbolt and remove the fan assembly.
-Disconnect the radiator hoses from the radiator.
-Disconnect the transmission cooling lines from the bottom of the radiator.
-Remove any clamps, brackets, or screws holding the radiator inside its frame.
-Lift the radiator up and out of the car.
4. Install the new radiator:
-Slide the new radiator into place.
-Connect any clamps or brackets that hold the radiator in place.
-Connect the transmission cooling lines carefully.
-Connect the engine cooling hoses to the radiator.
-Replace the fan and fan shroud.
-Reconnect the fan electrical connection.
-Replace the plastic covers.
5. Fill the radiator with fluid.
6. Check your work to make sure that there are no leaks.
(Tools need to be prepared: Screwdrivers, Wrenches, Drain pan)
Note:Do please keep children and pets away when replacing the radiator)
-----------------------------------------------------------------------------
Attention:
? project operation, the vehicle normal temperature 60 to 80 degrees.
? add detergent if the tank is too full can take some antifreeze.
| Item Specifics | |
|---|---|
| Brand | GDcar |
| Manufacturer Part Number | GD84409001 |
| Warranty | 1 Year |
| Radiator Placement on Vehicle | Front |
| Interchange Part Number | Engine Radiator and Radiator Cooling Fan |
| Listing Include | 1pcs Radiator Cooling Fan,1pcs Radiator |
| Other Part Number | Electric Radiator and Cooling Fan |
| Superseded Part Number | Electric Car Radiator and Cooling Fan |
| Condition | New |
| Type | Radiator and Cooling Fan |
| Fitment Type | Direct Replacement |
| Cooling Fan Voltage | 12 |
| Radiator Core Material | Aluminum |
| Radiator Tank Material) | Plastic |
| Fan Placement on Vehicle | Driver Side/LH |
| Cooling Fan Type | Radiator Cooling Fan Assembly,Single Fan |

Shop Category Delivery Help & Info Payment Policy Shipping Policy Return Policy FAQ About Us |
For 2016-19 HONDA CIVIC Car Electric Radiator & Radiator Cooling Fan Assembly
Fits: 2016-2019 HONDA CIVIC
Features: Easy Installation High flow design provides long lasting, efficient cooling The radiator cooling fan is an integral part of your car that is responsible for cooling the radiator of your car. The radiator cooling fan does this by either pulling or pushing air into the radiator keeping the radiator temperatures within the safe levels. A damaged radiator cooling fan is a determining factor in preventing your car from overheating. Below are the materials that you need along with the instructions on how to replace a radiator cooling fan.
Note: It is recommended to replace your Radiator Fan Clutch & Water Pump at the same time. The two parts age at the same rate so if one has failed, the other is probably not far behind. The fan clutch and water pump are also connected by the same shaft. When one part fails it typically affects the operation of the other. To prevent premature failure of your new unit, it is wise to replace both at the same time.
Radiator Notes: Specification: Core Material: Aluminum Tank Material: Plastic Quantity: 1pcs Radiator Warranty:1 Year limited Direct Replacement 100% brand new radiator (as picture showed) -------------------------------------------- ? Installation guidelines provided in the box ? Premium OE hardware and fittings included in every box ? OE design to ensure exact fit, form and function for an easy drop-in installation ? Maximum cooling efficiency and perfect fit ? Leak-tested aftermarket radiator ? SO 9001 certified manufacturing plants
How to replace a new radiator? 1. Disconnect the battery. 2. Drain the radiator fluid into a suitable container. 3. Remove the old radiator: -Take off any plastic covers around the radiator. -Disconnect the electrical connector to the fan, and unbolt and remove the fan assembly. -Disconnect the radiator hoses from the radiator. -Disconnect the transmission cooling lines from the bottom of the radiator. -Remove any clamps, brackets, or screws holding the radiator inside its frame. -Lift the radiator up and out of the car. 4. Install the new radiator: -Slide the new radiator into place. -Connect any clamps or brackets that hold the radiator in place. -Connect the transmission cooling lines carefully. -Connect the engine cooling hoses to the radiator. -Replace the fan and fan shroud. -Reconnect the fan electrical connection. -Replace the plastic covers. 5. Fill the radiator with fluid. 6. Check your work to make sure that there are no leaks. (Tools need to be prepared: Screwdrivers, Wrenches, Drain pan) Note:Do please keep children and pets away when replacing the radiator) ----------------------------------------------------------------------------- Attention: ? project operation, the vehicle normal temperature 60 to 80 degrees. ? add detergent if the tank is too full can take some antifreeze.
1. Orders processed within 24 hours of payment verification. (if you want cancel orders or change address pls contact us within 6 hours after payment, or we are not responsible for shipping a replacement.)
2. Fast shipping: All our packages use USPS First Class/UPS/Fedex... Package Service
3. If you have not received your shipment within 15 days from payment, please contact!
1. If you have a defected item under warranty, you can return it with 30 days after the pruchase date.
2. All returned items must be in the original packaging and you must provide us with the shipping tracking number, specific reason for the return, and item custom lable.
3. We will refund your full winning bid amount, upon receipt of the item in its original condition and packaging with all components and accessories included, AFTER both Buyer and Seller cancel the transaction from eBay. OR, you may choose to have a replacement.
1. We strive for 100% customer satisfaction! FEEDBACK IS VERY IMPORTANT TO US.
2. We request that you contact us immediately BEFORE you give us neutral or negative feedback, so that we can satisfactorily address your concerns.
1. We accept multiple payment methods.
2. If you want cancel orders or change address pls contact us within 6 hours after payment, or we are not responsible for shipping a replacement.
3. Payment must be received within 10 days as auction ended or order might be delayed.
1. We stand behind every product we sell.
2. We define the item as defective only if it doesn't function as described.
3. It is the buyer's responsibility to understand the item description before bidding.
4. Man-made damage by abuse or wrong operation is not covered by this warranty.
5. No product liability insurance is assumed.
All rights reserved. |
||||||||||||||||||||||||||||||||||||||||||||||||||||