ENERBITIOUS FOG LIGHTS ASSEMBLY for 2014-2016 MAZDA 3

Drivers can clearly see the front surroundings of the car via fog lights. ENERBITIOUS fog lights are heat-resistant, waterproof and dustproof. What's more,they have high brightness and long lifespan, ensuring your safety while still providing your vehicle with an eye-catching look.Constant improvement and innovation is our eternal aim. We hope you have a satisfying purchase in 'ENERBITIOUS' store.

IP67 WATERPROOF

ENERBITIOUS fog lamps have high-intensity testing, they can withstand various bad weather, like fog、snow and rain.So don't need to worry about quality problems when driving anywhere.

FOG LIGHT WIRING KIT INSTALLTION INSTRUCTION

1. Use right tools for the purpose and size of the work to be done to ensure proper work.
2. Please bind all harnesses together so that they do not move around loosely otherwise the harnesses may break or short circuit, and accidents, electric shocks or fire may occur.
3. When connecting the harnesses or plugs, insert the connectors firmly until they lock securely into place.
4. Disconnect the negative of the battery before installation. Make sure that lamps, air conditioner and other devices are switched off.
5. Open the hood and remove the front bumper if necessary, then install lights to the proper positions.
6. Route the main wiring harness (A) through the engine room to the lamp position and connect with bulb (B). Attach relay to relay box (C) then attach black wire (Negative) of main wiring harness to frame metal parts to create a ground circuit (D). Attach red wire (Positive) of main wiring harness to Positive of battery (E).
7. Route the main wiring harness(A-1) through cut grommet (F) and connect with main switch wiring harness(G). (Some car models may be pre-wired, then find out the correct circuit and plug it together.)
8. Remove the driver's dashboard lower cover if necessary, then find the power line of the parking lamp (Small lamp) (H-1) and connect with the red wire(Positive) of main switch wiring harness(H). Attach the black wire (Negative) of main switch wiring harness to metal frame to create a ground circuit (I). Then connect the switch (J) with switch connector (K) and put the switch to the night position (Usually it's on the dashboard but some car's switch position are near the hand brake.)
9. The lights operate only in the low-beam position. Adjust the light aiming according to your local laws and regulations.
10. If the lights don't turn on, check the fuse ( most car's fuse box is located in driver's dashboard lower cover) and all wire connectors.
11. The light lenses can cloud when the outside temperature is cold; this is normal and should go away in warm weather.
12. Do not touch the bulb. Oily or greasy substances on the bulb can shorten service life.