6pcs 9005+9006+9145 CSP LED Headlight Fog Light Bulbs Kit
  • High brightness CSP chip(USA),360 degree clear beam no blind zone
  • Engineering beam pattern design throw light on road evenly at appropriate angle without foggy light
  • Xenon white light reflect road paint/signs better to show clearer road situation
  • All-in-one aluminum profile as heat conduction system, 360 degree heat radiating, keep the light bulb in appropriate working temperature
  • Built-in constant current CPU,instant full brightness without start-up relay
Technical Details

Plug Type: 9005/HB3 High Beam + 9006/HB4 Low Beam + 9145/H10 Fog Light Bulb

Power: 100W/set(50W/bulb)

LED Quantity(each bulb): 2pcs* CSP 3570 chips

Luminous Flux: 10000LM/bulb

Operating Voltage: DC 9-36V(fit 12V,24V vehicles)

Color Temperature: Pure White 6000K

IP67 rated water and dust seal,360 degree beam angle

Material: Aviation 6063 aluminum profile

Operating Temperature: -40-80 degree Celsius

Over 50000hrs lifetime

Usage: headlight,fog light

LED Headlight Advantages
****LED lamps are more energy and power than conventional halogen lamps.
****The brightness is close to the xenon lamp, but the LED lights are illuminated without delay to enhance road safety.
****Instantly start without strong current impact, improve battery life by more than 30%.
****Fast cooling , using the most advanced, heat-dissipating structural design.
****The power driver adopts a wide voltage constant current mode which has a simple structure, so that the automobile can flexibly cope with various voltage unstable conditions, and has achieved the purpose of less component damage. Compared to HID ballast maintenance, The repair probability is very low which is less than 80%.
****Low heating temperature, The working temperature of helium can reach 800°-1000°
****LED headlight has a simple structure, and the parts are less than the xenon lamp, which is lower than the xenon lamp failure rate!
****Car LED headlight color temperature are balancing. Xenon bulbs are clear in the same color, about 6000K.
Install Caution
1. As a safety precaution, make sure that the car has had time to cool down properly before starting the installation process.
2. Put the vehicle into park or make sure it is securely in gear.
3. Be sure to turn off the ignition and remove the key.
4. Be careful to avoid burns, especially when turning on or off the vehicles lighting.
5. Be careful to avoid crushing or cutting the bulbs. Also make sure to not touch the bulbs with your fingers, as this will cause blotting.
6. Fully examine the connection of the contact points, ports and the wires as faulty connections can cause lighting problems.
7. Make certain that the end of the bulb does not come in contact with the interior light shield of the headlight when adjusting the bulb.

On Dec 8, 2025 at 00:24:01 PST, seller added the following information:

Datacaciques