New aluminium three piece wheels, supplied in kit form with all required nuts & screws as shown in the last picture.

These go together exactly like the original standard plastic wheels - not very easily! Try pushing the centre part of the wheel through the tyre sideways then turn it into the correct position once it's inside the tyre.  

These will fit straight onto the following models only:  Sand Scorcher, Grasshopper (not Grasshopper II/2), Hornet (not Super Hornet), Frog or Fighting Buggy (Super Champ) with rear wheel fittings with five holes in them for each screw to sit into. Some early/original versions do not have these holes so this screw set is not suitable for these, however we usually have the modern metal versions for the Sand Scorcher & other SRB's available in our Sand Scorcher parts listing HERE

The long screws & large spacers are for the rear wheels, the shorter screws & nuts are for the front wheels.

Note: Also included are two small black rubber spacers to go behind the rear wheel nuts (between the wheel and the nut). These are to protect the wheel from getting scratched by the wheel nut and they also help prevent movement of the wheel on the axle.

Please note the tyres may need to be glued to the wheels to prevent them spinning, just a few very small dots is usually enough to hold them in place so that they can be removed in the future if it becomes necessary (glue is not included).

Tyres & car not included!