Packing List: Climbing Welding Machine + Tool Accessory Kit + Tool Box + Manual Specification: Lap Width: 10cm Voltage: 110v 50hz Welding Material Thickness: Rubber Wheel 0.2-1.5mm Welding Seam Width: Two 12.5mm, Inspection Seam 12mm Power: 800w Welding Strength: ≥85% Base Material (Tensile Resistance in Shear Direction) Welding Speed: 0.5-5m/Min Whole Machine Weight: 5kg Product Size: 31*14*21cm (12.20*5.51*8.26inch) Heating Temperature: 0-450 Insulation Class: Class Li Power Fuse: 4a Motor Fuse: 1a Scope of Application: Suitable for Pe, Pvc, Hdpe, Eva, Pp

Features: 1. Intelligent Control, Control Box Feedback Type Intelligent Control System, Using Imported Components, Precise Control and Long Service Life. 2. Imported Silicone Pressure Roller, Good Elasticity, High Temperature Resistance, Suitable for Welding 0.2-1.5mm Materials. 3. Super Power Special Alloy Wedge Knife Supporting High-power Heating Tube (800w), Heating Faster 4. Pressure Adjustment Instructions Turn Clockwise to Adjust the Pressure to Increase, and Turn Counterclockwise to Reduce the Pressure; It Is Forbidden to Press the Two Pressure Rollers Together to Run Idly 5. Wide Range of Application Widely Used in Highways, Tunnels, Bridges, Reservoirs, Buildings, Artificial Lakes, Swimming Pools, Breeding Ponds, Landfills

Operation Procedure:

1. the Joystick Is Leveled to Separate the Upper and Lower Pressure Rollers to Prevent the Pressure Roller from Idling and Damaging the Machine After Starting the Machine.

2. Turn on the Power and Turn on the Power Switch.

3. Set the Temperature First. for Materials Above 1mm, the Temperature Is Adjusted to About 350 Degrees. When the Indicator Light on the Control Box Is Red, It Is Heating.

4. Adjust the Welding Speed According to the Thickness of the Material. According to the Normal 1mm Material, the Speed Is Adjusted to About 2.5m.

5. When the Red Light of the Control Box Turns to Green, Put the Materials in from the Left and Right Sides of the Machine, and the Joystick Is Driven from Bottom to Top, and It Is 90 Degrees to the Ground.

6. Adjust the Speed According to the Welding Effect, the Temperature Is High and the Speed Is Fast, on the Contrary, the Temperature Is Low and the Speed Is Slow (Try Not to Adjust the Speed and Temperature in the Middle,

Set the Temperature First When Turning on, If the Material Is Thinner or the First-time Operation, Set the Temperature Lower When Turning on)

7.After the Welding Is Completed, Immediately Level the Joystick to Separate the Upper and Lower Pressure Wheels (to Prevent the Pressure Roller from Being Burned by High Temperature), Then Adjust the Temperature Speed to the Lowest, and Finally Shut down and Unplug the Power Supply.