Einhell TP-ET 18 Edge Banding Trim Attachment

The worst part of edge banding is always to shave off the extra without damaging the edge banding or the wood/melamine i'm working with. I have tried several options but none gave met finish and confidence i was looking for

About this item

• This is a one piece solution which gives a very accurate result
• Has a large surface area to hold the router level on the workpiece
• Large surface ensures that the fingers stay well clear of the spinning router bit
• The large surface area ensures good level contact with the piece that needs to be trimmed to
• Large opening ensures that not only thin laminates can be trimmed but also solid oak edge banding (up to 30mm thick)
• Set up works best with a 1/2 router bit
• It will fit to the Einhell TP-ET 18 with the factory screws(4x)
• Designed by PLAWorkshop exclusively for SAS
• Build in the UK
• Colour may vary
• Quesiton please ask
• Not an OEM product