Product Description
Direct replacement - this diesel fuel injector matches the fit and functionality of the original equipment injector
Durable construction - this injector is remanufactured from quality materials for durability
Quality tested - this diesel fuel injector has been tested for quality and fit for this vehicle application
Function-Fuel injector transfers gas from the tank into the engine cylinders to provide power for the vehicle. Gas enters the fuel injectors in liquid form then transforms it into a mist then sprays it into the cylinder for efficient and quick burning of fuel.
How to Stop a Fuel Injector Leak.
Step 1
Raise the hood of the car an inspect the fuel injector rail while the car is running at idle. A strong odor of gasoline is a good indicator that there is a fuel leak. Look carefully, however, at the top and bottom of the fuel rail. Use caution: Fuel injection systems are under high-pressure and gas spraying out of the injector seal is highly combustible.
Step 2
Shut the car off immediately if a leak is present. Remove the fuel pump fuse, wrap the leaking injector with a shop towel to soak up the gasoline and start the car. Allow the car to run until it stalls. This step relieves the fuel pressure in the fuel rail and the rail can safely be removed.
Step 3
Disconnect the injector wiring harness and remove the fuel rail bolts that hold the rail in place. Remove any associated fuel lines or hold-down clamps that will prevent the rail from being lifted up to unseat the fuel injectors from the engine. Once it is loose, lift the rail up and remove each of the injectors. They are held in place by snug-fitting O-rings and are easily pulled out. It is not necessary to keep them in order.
Step 4
Remove the upper and lower O-ring seals on the injectors. Place the injectors in a carburetor soaking basket and drop the basket in a bucket of carburetor cleaner. Allow the injectors to soak for several hours to thoroughly clean them of carbon deposits. After soaking, rinse the injectors with clean water and immediately blow them dry with compressed air.
Step 5
Install new O-rings. Make sure the O-rings are designed for use with gasoline and fit the vehicle being serviced. O-rings will quickly deteriorate and fail. Lightly coat the injectors with petroleum jelly and insert them into the fuel rail.
Note
Please check again whether the types you choose are accordance with your make before you pay your order.If you have any concerns about how to choose the type,please send your make/model to us,we can support some relative information for your reference.Please feel free to contact with us,if you have any questions.
