Item specifics

• Condition:New
• Part Type:Steering Pump
• Interchange Part Number:21-5919  56110-PAA-A01  96-5919
• Material:Metal
• Type:power steering pump
• Holes:As picture shows

 

 

Features & Details

 

• 【PREMIUM QUALITY】- This steering pump is made of high-quality material and maintains an excellent strength to give the parts long-term performance. It can be installed easily without using complicated tools.
• 【FUNCTIONAL STEERING PUMP】- The power steering pump is used to converting power to the power steering fluid from the reservoir into the steering gear and keeps the wheels running in the right conditions. 
• 【OEM PART NUMBER】- This power steering pump is designed and manufactured with OEM standard. The Part Number is 1ASPP0002712.
• 【DIRECT REPLACEMENT】- This steering system pump is a direct replacement though it is NOT a genuine part. If your original power steering pump is failing or leaking, this replacement steering pump could be your solution. 
• 【VEHICLE INFORMATION】- This power steering pump fits for 1998-2002 For honda Accord 2.3L SOHC 56110-PAA-A01. And please double-check the fitment information on the following product description.

 

 

 

Fits for:

For 1998-2002 For honda Accord  2.3L 2254CC l4 GAS SOHC
 

 

Package Includes:

1 x Power Steering Pump

 

 

Precaution of installing Power Steering Pump

      Please pay attention to the following instructions during the Power Steering Pump installation,to avoid any loss. 
 

•  1.  To prevent any trash and metal chips inside hydraulic pipe flowed into the pump,thus oil leak,abnormal noise and turning hard happened,steering system hydraulic pipe wasted oil should be released and cleaned.

 

• 2.  Before assembling the high pressure connector,enough fresh hydraulic oil should be poured into the pump from high pressure oil mouth to avoid non oil absorption in low speed,then install the high pressure pipe connector and other pipeline ,all the pipeline joint should be fixed tightly without loose or oil leaking hidden trouble.

 

• 3.  Enough steering oil should be poured into the oil reservoir,start the engine,drive the steering pump in low speed,and make sure the whole steering system full with steering oil,meanwhile,the fluid level of oil reservoir will be dropped rapidly during the oil pouring,so continuous oil filling is required to prevent air absorption in the pump.

 

• 4.  Turning the steering wheel from one limiting position to another limiting position,and repeat 10-15times.

         Don't stop in the limiting position over 5 seconds.
          Don't use over strength in the limiting position,otherwise the fluid stays foamy.
         Repeat the above action,until no bubble leaked out.
 

• 5.  In the process of installing pump transmission belt,tension force should be moderate,otherwise,abnormal abrasion & noise,premature damage,oil leakage & hard steering force will be shortly happened in case of too tight tension force.

 

• 6.  All standard operation should be followed during the installing,hammer and other objects knocked is strictly forbidden.We are not responsible for any nonstandard installing damage,except the quality defect.

      Note: Abnormal noise and reservoir oil foam will be happened during the trial run unless correct venting,because of remained air stayed in steering system,affer running 10-20kms,all the remained air will be released,and the noise will be disappeared.