Features:

Condition:100% Brand New
Color:Black
Light Color: Red/Blue/Green
1-6 Gear display

Instructions Guide:

You need to connect 4 wires to the bike’s wiring harness. Good quality quick connectors are supplied (4 pcs wire taps). No need to cut any wires and no need for soldering.
All connections can be done either under the fuel tank, at the ECU box or behind the instrument cluster.

The table below shows the connection overview:

GFYSHIP wire	Connect to
Red	+12V switched power lead
Black	Ground lead or chassis ground
White	Speed Signal, tap anywhere between the Speed Sensor and instrument cluster. On some ABS models, tap the speed signal anywhere between the ABS computer and ECU box.

Green	Tacho signal, tap anywhere between the ECU box and instrument cluster. Alternatively, tap the signal wire from the 2-wire Crankshaft Sensor (Pickup coil), anywhere between the sensor and ECU box.

To complete the install, it is recommended that you consult with your dealer and/or refer to the Service Manual available for your bike.
Due to the large number of bike models and vehicles compatible with this Kit, model specific wire colors and install instructions are not described in this document.

1. The ignition key should be in OFF position. Remove the seat, raise and support the fuel tank

2. Locate the Speed Sensor coupler.

A. Most motorcycles have the speed sensor mounted on the gearbox. Others have the sensor mounted either at the front or at the rear wheel.

B. Trace the cable until you find the speed sensor coupler. It is a 3-pole connector (except BMW, which use 2-pole).

C. If in doubt, check the bike’s Service Manual or ask your dealer for the location of the Speed Sensor coupler.

Confirmation:

Separate the Speed Sensor coupler. Rotate the wheels while the ignition is on. The speedometer should indicate 0. If so, turn the ignition off, reconnect the coupler and proceed to the next step. Otherwise, if the speedometer registers a speed other than 0, you have not disconnected the correct coupler and need to look again.

ABS models:

Some bikes equipped with ABS do not have a speed sensor (e.g. Yamaha FJR1300 2006+, VMAX 2009+, Ducati ST4 2005+). The speed signal is generated by the ABS computer.

On these bikes, tap the speed signal wire between the ABS computer

and ECU box. Refer to the bike’s Service Manual for the wiring.

3. Connect the GFYSHIP Black wire to the Ground wire of the sensor, using the Red wire tap connector supplied.

4. Connect the GFYSHIP Red wire to a switched +12V power lead, such as the hot wire of the rear brake light switch, or to a power lead at the fusebox. You can use the Power lead of the speed sensor if its voltage is higher than 9V.

Again, use the Red wire tap connector supplied.

6. Connect the GFYSHIP Green wire to the Signal wire of the Crankshaft sensor (Pickup coil). The Crankshaft sensor is inside the crankcase, usually near the alternator. It has two wires. Alternatively, tap the tacho signal wire near the ECU box. Again, use the Red wire tap connector supplied.

Setup:

You need to setup the module after installation. When ignition is turned on, the

display counts backwards (6 to 1) indicating that the memory is clear.

- Raise the rear wheel off the ground by using a stand, and start the

engine in Neutral. (If you do not have a stand, you may setup the unit while

riding. Find a long, straight road with light traffic.)

- The display will blink “1”. Select first gear, release the clutch, and keep the RPM above idle speed.

The display is blinking faster while the unit is learning the gear.

- When the display shows “2”, select second gear. Repeat this process until all gears are thought (5 or 6). The unit is programmed and should indicate the gears correctly.

Now, when ignition is turned on, the display counts forward (1 to 6) indicating

that it is fully functional.

Package Include:

1 x Gear Indicator

Fitment:

For Yamaha BT1100 Bulldog      2002-2006

For Yamaha Diversion NON ABS      2009-2015

For Yamaha Drag Star      1999-2006

For Yamaha FJR1300 NON ABS      2001-2005

For Yamaha FJR1300 ABS      2003-2005

For Yamaha FZ-16 / FZ-S      2008-2015

For Yamaha FZ400      1997-2002

For Yamaha FZ6 NON ABS      1998-2012

For Yamaha FZ6 ABS      2006

For Yamaha FZ6R      2009-2017

For Yamaha FZ8 NON ABS      2010-2015

For Yamaha FZ1      2001-2017

For Yamaha FZH150      2015

For Yamaha FZN150      2015

For Yamaha FZS600 Fazer      1998-2003

For Yamaha FZS1000 Fazer      2001-2015

For Yamaha MT-01      2005-2012

For Yamaha MT-03 NON ABS      2006-2013

For Yamaha Raider      2006-2018

For Yamaha Roadliner      2006-2015

For Yamaha Road Star      1999-2014

For Yamaha Royal Star ALL Variants      1996-2013

For Yamaha Stryker      2011-2017

For Yamaha Stratoliner      2006-2015

For Yamaha TDM850      1999-2001

For Yamaha TDM900 NON ABS      2002-2013

For Yamaha TDM900 ABS      2004-2006

For Yamaha V-star (950cc and above)      ALL YEARS

For Yamaha Warrior     2002-2012

For Yamaha WR250R / X     2008-2020

For Yamaha WR450R / X     2008

For Yamaha XJ6 NON ABS     2009-2015

For Yamaha XJR400     2002-2007

For Yamaha XJR1300     2004-2017

For Yamaha XT660     2004-2015

For Yamaha XV1600A Wild Star     1999-2005

For Yamaha XV1900A Midnight Star     2006-2017

For Yamaha XVS950A Midnight Star     2009-2016

For Yamaha XVS1100 Drag Star     1999-2011

For Yamaha XVS1300A Midnight Star     2007-2015

For Yamaha YS250 Fazer     ALL YEARS

For Yamaha YZF-R6   1998-2016

For Yamaha YZF-R6S   2006-2009

For Yamaha YZF-R1   1998-2008

ATV

For Yamaha Big Bear   ALL YEARS

For Yamaha Grizzly    ALL YEARS

For Yamaha Rhino   ALL YEARS

For Yamaha YFM550   ALL YEARS

For Yamaha YFM660   ALL YEARS

For Yamaha YFM700   ALL YEARS

For Yamaha YFZ450   ALL YEARS