Uses stainless fasteners to lock into place. Foam can be added to the top (where screwdriver is pointing in last photo) to give a tighter fit once pressed into place.
Installation:
1. Remove Garage door opener panel
2. Slide CB mount in and tighten pivot screws, preferably after routing your power and hooking up your antenna cable.
3. Angle mount down to be able to access CB Mount screw holes.
4. Slide CB mount into place and install 2 included CB Mount Screws
5. Pivot the mount up and it snaps into place. If mount is loose, a piece of foam can be put under as a shim to tighten up the fit.
Does not come with CB Radio.
Included:
1 CB mount
2 Pivot screws
2 Pivot Nuts
2 CB Mount screws (M4x18mm)
Made of PETG to hold up to all temps.
Made in USA with USA materials