This bell press has a porcelain “PULL” disc and the solid brass dish sits inside a solid teak back plate. 

It comes complete with full fitting instructions, fixings and blanking pulley for inside the house.

Also included is the internal bell (also pictured) and pull cord.

The bell is mounted onto an oval teak backplate. 

It comes complete with one extension pulley, one directional pulley, 4 metres of cord, fixing screws and full fitting instructions.

IMPORTANT - Please note that this product requires a minimum of 130mm depth to accommodate the tempered return spring at the rear of the pull. For best results, the internal bell should be located no more than 3 metres from the pull.

Please note this product is unlacquered and will develop own patina over time for aged look.

Bell pull measurements:

Bell pull measurements:

Faceplate – 180 x 180mm

Projection (in front of brickwork) – 65mm

Projection (into brickwork) – 120mm

Internal bell measurements overall:

Height – 290mm

Width – 230mm

Projection 130mm

Oval plate 230 x 180mm