Excerpted technical parameters from the parameter table UC4000-30GM-IUR2-V15

General characteristics

Sensing distance: 200 ... 4000 mm

Adjustment range: 240 ... 4000 mm

Dead zone: 0 ... 200 mm

Standard target board: 100 mm x 100 mm

Transducer frequency: approx. 85 kHz

Response delay: minimum 145ms

Factory setting is 440ms

Indicator light/operation key

Green LED: Steady on: Power on

Blinking: Target detected in standby mode or TEACH-IN function

Yellow LED 1 is always on: the target is within the detection range

Flashing: TEACH-IN function

Yellow LED 2 is always on: the target is within the detection range

Flashing: TEACH-IN function

Solid red LED: temperature/setting plug not connected

Blinking: Error or no target detected in set state

Temperature/TEACH-IN connector Temperature compensation , Evaluation range programming , output function setting

Electrical Characteristics

Operating voltage: 10 ... 30 V DC , ripple 10 %SS

Power consumption: ≤ 900 mW

interface

Interface type: RS 232, 9600 Bit/s , no parity, 8 data bits, 1 stop bit

input/input

Sync: Bidirectional

0-level -UB...+1 V

1-level: +4 V...+UB

Input Impedance: > 12 KOhm

Sync pulse: ≥ 100 μs, Sync pulse period: ≥ 2 ms

Sync frequency

 Normal working mode max. 13 Hz

 Multimode ≤ 13 Hz / n , n = number of sensors , n ≤ 5

output

Output type: 1 current output 4...20mA

1 channel voltage output: 0...10V

Resolution: evaluation range [mm]/4000, but ≥ 0.35 mm

Characteristic curve deviation: ≤ 0.2 % of full-scale value

Repeatability: ≤ 0.1 % of full-scale value

Load impedance: current output: ≤ 500 Ohm

Voltage output: ≥ 1000 Ohm

Temperature drift: ≤ 2 % from full-scale value (with temperature compensation)

≤ 0.2 %/K (without temperature compensation)

Licensing and Certification

UL Listed cULus Listed, General Requirements

CSA Certification cCSAus Listed, General Purpose

CCC Approval Products with a maximum operating voltage of 36 volts do not require approval approval and therefore do not require the CCC-Mark.

surroundings

Ambient temperature: -25 ... 70 °C (-13 ... 158 °F)

Storage temperature: -40 ... 85 °C (-40 ... 185 °F)

Mechanical properties

Wiring Type: Connector M12 x 1 , 5-pin

Protection class: IP65

Material  

Housing: stainless steel 1.4305

Plastic part PBT

Transducer Epoxy/hollow glass sphere blend; polyurethane foam

Weight 210 g