• 100% quality assurance tested, more responsive, less expensive, easier to install.
• Precisely trimmed solenoid windings enable optimum fuel delivery.
• High-temp O-rings enable prolonged sealing of injectors under extreme heat conditions.
• Help you attain maximum fuel efficiency and power from your engine.
• Keep your vehicle performing reliably, efficiently, and safely for many miles to come.
• Promote smooth engine operation and balanced fuel delivery reducing overall fuel consumption and harmful emissions.
• Stainless-steel calibration slide and spring assembly prevent corrosion within the fuel control body leading to extended service life.

Specification:

Fitment

For 96-05Chevrolet Astro V6 4.3L.
For 96-05 Chevrolet Blazer V6 4.3L.
For 96-98Chevrolet C1500 V6 4.3L.
For 96-04 Chevrolet Express V6 4.3L.
For 96-98 Chevrolet K1500 V6 4.3L.
For 96-99 Chevrolet P30 V6 4.3L.
For 96-04 Chevrolet S10 V6 4.3L.
For 99-04 Chevrolet Silverado V6 4.3L.
For 96-98GMC C1500 V6 4.3L.
For 02-96GMC Jimmy V6 4.3L.
For 96-98 GMC K1500 V6 4.3L.
For 96-05GMC Safari V6 4.3L.
For 96-04 GMC Savana V6 4.3L.
For 99-04 GMC Sierra V6 4.3L.
For 96-04GMC Sonoma V6 4.3L.
For 97-00Isuzu Hombre V6 4.3L.
For 96-01Oldsmobile Bravada V6 4.3L.

Vehicle compatibility charts are for REFERENCE ONLY. Check your vehicle with OEM below to match your needs.

OE Number:

Fuel Injector: 19210688, 12568332, 88894353.
Fuel Injector Motor: 17113273.

Replace Manufacturer Part Numbers:

FJ503, FJ10565, 217-3028, 2173028, 89060439, 833-22102-6, 25331863, 800-1512N, 17113295, 17114164, 17091628.

Package Includes:

1x Fuel Injector;
1x Retaining Bracket with Bolt.

Installation Instructions:

1. Disabling the vehicle’s fuel pump， disconnect the battery
2. Remove the airbox system, throttle body, wiring harness connectors, and the PCV valve and hose.
3. Remove the Upper Intake Manifold cover and SCPI Fuel Meter Body
4. Remove the Fuel Meter Body bracket and replace it with the updated bracket.
5. Insert the MFI Fuel Meter Body into the Fuel Meter Body Bracket on the Lower Intake Manifold. Push down firmly on the fuel meter body locking it into the bracket.
6. Apply a coat of clean motor oil or non-silicone lubricant to the injector tip for easier installation.
7. Insert the number 3 injector into the correct hole in the Lower Intake Manifold first. Install the number 5 injector next and then number 1.
8. This sequence must be followed correctly to prevent interference of the Fuel Tubes. Injectors 2, 4, and 6 are then installed.
9. Temporarily reinstall the Fuel Inlet and Return Lines into the Fuel Meter Body.
10. Reconnect the battery and vehicle’s fuel pump.
11. Perform a Fuel Pressure System check to verify that the injectors are not leaking.
12. If everything is ok, reinstall the Upper Intake Manifold cover and Fuel lines.

NOTE: