These are universal mudflaps, not made for one model. They fit most cars, front or rear, left or right. Before you buy, check these 3 things:

1. Size. Each flap is 300 mm long and 210 mm wide across the bottom. Hold a tape measure up to your wheel arch to see how it will look.

2. A flat edge to screw into. You need a flat surface of about 10 mm on the edge of the front or rear arch (or the bumper). If you have it, the flaps simply screw on (screws included) - you may need to drill small guide holes.

3. Rolled arches? If your arch edge is rolled and there is no 10 mm flat surface, you will need trim clips instead of screws. These are cheap and sold at any motor factors.

Vans, pick-ups and large 4x4s: these flaps are sized for cars and on most vans and large 4x4s they are too small to cover the wheel properly - we do not recommend them for those vehicles.

Please note: because these are universal mudflaps, we cannot confirm the fit for a specific make or model. Please check the size and the flat edge on your own vehicle using the 3 points above before you buy.

1. Line the mudflap up with the edge of the bumper / wheel arch.

2. Mark the screw holes and drill small guide holes if needed.

3. Screw the flap on with the screws supplied (or fit with trim clips on rolled arches).

Tip: on the front, turn the steering to full lock to make room. With larger rear wheels you may need to take the rear wheel off to fit the rear flaps.