Axial SCX10 III SCX10 third-generation broken steering gear/shift protection modification, industrial-grade MJF 3d printing technology (comparable to non-diy-grade printers), high material strength, excellent mechanical properties, can be directly installed.
This kit is for one car and includes kits for two steering gears.
Note:
This kit needs to use a 25t standard futaba steering gear output gear, and Power HD tr4 steering gear is recommended (why choose it? Metal gear, high pressure, waterproof, digital mode, the reliability of other small servos is not satisfactory)
Steering gear protection installation method:
1. It is recommended to leave the group before installation (make a gesture);
2. Turn on the remote control power, enter the channel end point (END POINT) and set the left and right end points of the servo channel at about 10%;
3. Turn on the ESC and power on the steering gear to ensure that the amount of the steering gear is at the midpoint position relative to the movement of the shift control arm. Insert the protective part of the steering gear into the steering gear, and screw the top wire (machine screw) at both ends. ). Note, please do not use an electric screwdriver; do not force miracles, just meet obvious resistance;
4. Install the shift rocker arm, spring and other components in sequence according to the original factory instructions;
5. When installing the top cover, please do not screw the top cover screws to the end. It is recommended to leave a gap of about 1mm between the top cover and the shift rocker arm;
6. Adjust the dead point of the steering gear to a proper position.




