Fitment:

For 2007-2012 Nissan For Altima 4-Door Sedan

Please carefully check whether the product matches your own car model before buying.
If you have any questions, please contact us in time.

Package include:

2 x Taillight Assembly

Features:

• Made to high quality and high standards
• High corrosion resistance and long service life.
• Perfect after-sales guarantee and distribution advantages.
• One year warranty,Free 30 day returns.
• Direct Replacement,Easy to install.
• 100% new brand condition.
• Fully equipped with headlights (driver and passenger side).
• The appearance is good, it can bring different appearances to the vehicle, it is very suitable for display purposes or replacement of old and worn headlights, and the quality is also very good.

​

How to install：

• Loosen the screws, clips, or retaining springs that hold the headlight in place.
• Disconnect the wiring from the assembly.
• Remove the headlight from the vehicle and replace it with a new one.
• Install the new headlight assembly.
• Hold the new headlight in place, making sure the screws, clips, or retaining springs used are sealed.
• Reconnect the wires removed from the components.
• Put back the grille and other components you removed. Seal them back in place.
• Test the new component.

​

​How to adjust the headlight assembly：

    Check the alignment of the lights first. Park the vehicle about 10 to 25 feet away from the wall with the light pointed at the wall. The centerline of the headlights should not be 3.5 feet above the ground.

1. Locate the adjusting screw.
2. Adjust the headlights individually. The headlights should be adjusted one at a time. Put a rag or towel on the chair in front of the light you want to block. (NOTE: Directly covering the lamp assembly will damage the plastic lens.)
3.  Adjust the vertical field. The screw on the top of the lampshade should be turned clockwise to raise the lamp and counterclockwise to lower the lamp. The headlamp should be adjusted until the top of the most intense part of the beam is directly on the center of the tape line on the wall or just below the center of the tape line.
4. Test your results.