The package includes the following items:
1 x Ambient piano black centre climate control trim, LED colour combo: orange + ice blue
1 x Ambient cupholder LED, LED colour combo: orange + ice blue
2 x Ambient footwell LED, LED colour combo: orange + ice blue (the footwell lights illuminate white when the door is open and remain normally illuminated as ice blue and orange when the door is closed, switching between the infotainment system and the ambient lighting).
The LEDs has two colours built in (orange & ice blue) which are switchable in the BMW's Idrive ambient light setting. "Sport" = ice blue, "Classic" = orange. The brightness can also be adjusted in the Idrive ambient light setting. These replacement LEDs are significantly brighter than the car's original LED, greatly enhancing your night time driving experience. The lights will remain lit while you drive. The LED will turn on when the headlight is turned on.
Vehicle Fitments:
3 Series F30 F31 F34
4 Series F32 F33 F36
M3 F80
M4 F82 F83
Please check if your vehicle is already equipped with the cupholder LED, if your vehicle is not equipped with the cupholder LED, additional wiring may be required. Most of the models listed above will have the cupholder LED from the factory.
Installation instructions:
Cupholder LED:
1. Use a trim tool to remove the trim piece under the centre climate control trim
2. Take out and disconnect the car's original cupholder LED light
3. Connect the new replacement cupholder LED light
Climate control trim: (a printed detailed installation guide with photos will be provided)
1. Remove the centre dash air vent trim
2. Use a T20 torx screwdriver to remove the 4 screws holding the climate control trim
3. Use the small pick tool provided in the kit to unclip all the clips holding the climate control switch modules onto the trim
4. Transfer the switch modules into the new replacement trim and plug it into the power source
5. Install everthing back in reverse order
Footwell LED:
1. Use the small pry tool provided to pry off the original LED assembly
2. Disconnect the original LED and connect the new replacement LED


