📝 Step-by-Step Usage Guide
Part 1: Blemish Care with Dedicated Tips & Special Film
- Tip Installation: Rotate the head cover counterclockwise to loosen, insert the blemish tip into the collet, then tighten the head cover clockwise to secure.
- Film Application: Peel off one protective layer from the special film, stick the adhesive side to the tip top, then put on the tip cover.
Note: Push the tip fully into the cover to ensure proper positioning. Plasma activates only when the film’s ring area touches the skin.
- Operation: Set to Continuous (C) mode, intensity level 7–9. Hold the operation button and slowly move the tip in circular motions over the blemish area.
Important: Only use disposable dedicated films. A damaged film will cause direct spark contact and may irritate skin. Do not reuse films.
Part 2: Blemish Care with Acne Patches
- Tip Installation: Follow the same steps to install the blemish tip.
Note: Remove all special film before using with acne patches — no film is required for this mode.
- Patch Application: Clean and fully dry the target area (do not apply toner or lotion beforehand). Stick an acne patch directly onto the blemish. Do not use damaged patches.
- Operation: Set to Continuous (C) mode, intensity level 7–9. Press the button and move the tip slowly in circles over the patch. Plasma helps the skin absorb active ingredients from the patch while soothing blemishes.
Important: Keep the tip on the patch only. Direct needle-skin contact may cause skin damage.
Part 3: Plasma Lifting for Wrinkle & Collagen Care
- Tip Installation: Loosen the head cover counterclockwise, insert the lifting tip into the collet, then tighten clockwise to lock.
- Operation Guidelines:
- The device will NOT power on while charging.
- For Pulse (P) mode, keep intensity at level 1–5 only. This 500Hz pulse mode is designed exclusively for lifting; levels above 5 may cause unnecessary skin irritation.
- Clean and dry skin thoroughly before treatment. No skincare is required during the lifting session, but you may apply conductive gel or lifting cream if preferred.
- Use a light tapping or brushing motion — plasma discharges on skin contact. Adjust intensity based on the treatment area.
Part 4: Skincare Absorption Boost (Fractional & Penetration Tips)
- Fractional Tip Prep (5 mins): Install the fractional tip. Clean and pat skin dry. Set to Continuous (C) mode, intensity 3–5. Gently tap across the treatment area.
- Apply Skincare: Smooth your serum or cream evenly over the skin.
- 1st Absorption Massage (5 mins): Switch to the penetration tip. Set to Continuous (C) mode, intensity 5–7. Gently massage to drive ingredients deeper into skin.
- 2nd Absorption Lock (5 mins): Reinstall the fractional tip. Set to Pulse (P) mode, intensity 3–5. Lightly tap skin to seal in skincare benefits.
Part 5: Plasma Arc Needle for Spot & Skin Tag Care
- Needle Installation: Unscrew the head cover counterclockwise. Replace the standard collet with the needle collet. Insert the needle tip into the clip, then retighten the head cover.
- Operation: Select intensity level 3–7 and Continuous (C) mode. Press the button, hold the tip within 1mm of the target area, and plasma will be delivered to the spot.
Charging Instructions
Charge via the included USB cable, compatible with PC, laptop and standard USB adapters. The device cannot be used during charging for user safety.
- 1 x Plasma Pen Main Unit
- 1 x USB Charging Cable
- 1 x User Instruction Manual
- 1 x Small Suction Tube
- 10 x Silver Fine Needles
- 2 x Gold Straight Needles
- 2 x Gold Curved Fine Needles
- 1 Sheet of Acne Patches (8 pcs)
- 1 x Blemish Treatment Tip
- 1 x Blemish Tip Cover
- 1 x Small Roller Head
- 1 x Medium Flat Round Head
- 1 x Plastic Suction Head
- 1 x Flat Abrasive Head
-
🛡️ Battery & Safety Notes
- The rechargeable lithium battery has an average lifespan of 500 charge-discharge cycles. Battery life may decrease under extreme temperatures, high humidity or improper operation.
- Do not store the device fully drained for long periods, as this will permanently reduce battery capacity. Charge fully after first use and before long-term storage.
- For safety, the device is disabled during charging. Do not attempt to use it while plugged in.
- Always follow recommended intensity levels and usage durations to avoid skin discomfort.