Application

 It is suitable for small boats under 9.8ft. It is suitable for fishing, aquaculture, outdoor adventure, water sports, water tourism, water rescue, and other fields.

Oil Mixing Ratio

Specifications

Material: Plastic, Aluminium Alloy, Steel, Rubber

Color: Black, Orange

Surface Treatment: Spray Molding

Type: 2 Stroke Engine,  Air Cooling

Assembly Required: Yes

Carburetor Type: Diaphragm Type

Cooling System: Forced Air Cooling

Mounting Type: ‎Boat Ramp Outboards

Gear: CVT ( Without Reverse Gear )

Ignition System: Electronic Ignition

Trim and Tilt System: Manual

Operation Mode: Manual CVT

Gasoline: Mixed Oil (25:1 Mix of Gasoline and Two-stroke Engine Oil)     

Propeller Specification: 3-blade Aluminum Alloy( Diameter is 18cm/7.09in )

Shaft Length: Short Shaft (For Kneeling Board Within 45cm/17.72in From the Water Surface)

Displacement: 52cc

Horsepower: 2.5 HP

Fuel Tank Capacity: 1L/0.26gal

Fuel Consumption: 0.6-0.8L/0.16-0.21gal/hours

Power: 1.82kw  

Rotation Speed: 8500rpm

Full Fuel Running Time: 40-70min

Applicable Boat Size: Within 3m/9.84ft

Gross Weight: 10.2kg/22.49lbs

Product Size: 25*24*107cm/9.84*9.44*42.12in

Operating Rod Length: 56cm/22.04in

Package Size: 110*28*28cm/43.31*11.02*11.02in

Package Included

1*2.5 HP 2-Stroke Outboard Motor

1*Fuel Oil Mixing Bottle

1*Funnel

1*Mounting Bracket

1*Toolkit Bag

All Accessories for Installation

Notes

• Two-stroke air-cooled engines must use TCW-2 engine oil, which must be specifically designed for outboard engines.
• Fuel mixture ratio: 25:1 for the first 50 hours, 50:1 after 50 hours.
• Two-stroke outboard engines must use a mixture of 92# gasoline and two-stroke engine oil.
•  During the break-in period, the volume ratio of gasoline to oil is 25:1.
•  After the break-in period, the volume ratio of gasoline to oil is 50:1.
•  Important note: Gasoline and oil must be pre-mixed and thoroughly stirred before being poured into the fuel tank.
• The outboard motor must be started in water, please do not start the engine on land.
• When starting the engine, loosen the vent screw on the fuel tank cap counterclockwise.
• When starting the outboard motor, insert the emergency stop rope and secure the other end to your wrist or belt
• The break-in period lasts approximately 10 hours or one month. Please avoid operating the engine at high throttle during the break-in period.
• After the break-in period, replace the gear oil. The second replacement should be performed after approximately 100 hours or six months.
• Please note that gearboxes are supplied with gear oil from the factory, but this needs to be changed regularly, depending on the frequency of use.
• Please read the operating manual and label completely before use, and pay particular attention to the safety instructions included. Please note that the speed is certainly not the same when one person is on it or many people are on the boat. Please don't start the motor on the bank. If you want to test the motor, it should be done in the river. Please don't use the motor when it stops coming out of the water.
• Please note that gasoline is prone to oxidation and degradation during storage. Using degraded gasoline can clog fuel lines and cause starting difficulties. If the engine has not been used for more than half a month, please drain the fuel, in advance.
• Please note that the propeller can withstand fresh water, but we do not recommend using it in salt water.
• Please prepare enough fuel according to the sailing distance. Please carry a life jacket and hand paddle (both not included). Please check the installation of the outboard motor before sailing.
•  Please note that all gasoline engines make noise, but this is normal. We recommend you prepare a boat-motor stand or hanging board (both not included) on your boat. The use of fishing gear should comply with national laws and regulations, comply with local government water control, protect the environment, and cherish the ecology.             
•  If you need to accelerate, please accelerate slowly, please don't accelerate sharply or it will increase the wear and tear of the clutch.
• Please note that if the product is not used for a long time, please fuel drain the excess fuel in the carburetor to improve the service life.
• Please allow the slight color difference caused by the shooting light and 1-3cm error due to manual measurement, and make sure you do not mind before you order.