Application:

• For 11-11 BMW 1 Series M 3.0L 6 Cyl.
• For 08-12 BMW 135i 3.0L 6 Cyl.
• For 07-12 BMW 335i 3.0L 6Cyl.
• For 07-08 BMW 335xi 3.0L 6 Cyl.
• For 09-12 BMW 335i xDrive 3.0L 6 Cyl.
• For 08-12 BMW 535i 3.0L 6 Cyl.
• For 10-12 BMW 535i GT 3.0L 6 Cyl
• For 11-12 BMW 535i GT xDrive 3.0L 6 Cyl.
• For 08-08 BMW 535xi 3.0L 6 Cyl.
• For 09-12 BMW 535i xDrive 3.0L 6 Cyl.
• For 12-12 BMW 640i 3.0L 6 Cyl.
• For 11-12 BMW 740i 3.0L 6 Cyl.
• For 11-12 BMW 740Li 3.0L 6 Cyl.
• For 11-12 BMW X3 xDrive35i 3.0L 6 Cyl.
• For 11-12 BMW X5 xDrive35i 3.0L 6 Cyl.
• For 08-12 BMW X6 3.0L 6 Cyl.
• For 09-16 BMW Z4 SDrive35i/ SDrive35is 3.0L 6 Cyl.

Vehicle compatibility charts are for REFERENCE ONLY. Check your vehicle with OEM below to match your needs.

OE Number:

• 13517616170, 13517585655, 13517592881, 13517594943, 13517596123, 13517613933, 13537537320, 13517616446, 13517616194

Specification:

• Quality assurance tested, more responsive, less expensive, easier to install.
• This is the most up to date version of this fuel pump.
• Accurately and precisely spray the proper amount of fuel into the engine.

Material & Color:

• Material: made of high quality Iron.
• Color: as picture.

Package Included:

• 1x High Pressure Fuel Pump.(Brand New Never Used Or Installed)

Installation Instructions:

• Remove fuse 70 in the glovebox, take off the negative battery.
• Remove upper filter housing and side covers.
• Loosen hose clamp,remove air filter.
  
• Loosen hose clamp, bolt and electrical connector from .Remove the air charge tube from throttle body.
• Remove the plastic vacuum hose from the bottom of the valve by squeezing the plastic ring and pulling off.
• Remove the four throttle body bolts and pull loose from intake manifold. Push to side out of the way.
• Grab the wiring harness and pull out and off of mounting bracket. Push out of the way.
• Disconnect engine block electrical connector behind fuel pump and from back of fuel pump.
• Remove the electrical connection, wiring bracket.
• Remove vacuum line that runs from the cylinder head cover to the auxiliary vacuum pump.
• Unscrew the nuts anchoring the intake manifold and remove it.
• Loosen the nut, Remove the two wiring harness bracket bolts, pull rear fuel line.
• Loosen the nut, disconnect the top fuel line from fuel rail then remove fuel line from engine .
• Unscrew the three mounting bolts , remove old fuel pump from vehicle
• Verify the new fuel pump comes with a new o-ring before installing.
• Make sure the auxiliary vacuum pump (where fuel pump mounts to) is clean.
• Install the new BMW high pressure fuel pump.
• Reinstall fuel lines, intake manifold, throttle body, air intake and cabin filter.Start car and test system.