Fitment:
2007-2008 SCION TC
2004-2006 SCION XA
2004-2006 SCION XB
1998-2009 TOYOTA 4RUNNER
2005-2008 TOYOTA AVALON
1997-2006 TOYOTA CAMRY
1995-2008 TOYOTA COROLLA
2000-2005 TOYOTA ECHO
2007-2012 TOYOTA FJ CRUISER
2003-2008 TOYOTA MATRIX
2004-2009 TOYOTA PRIUS
1996-2005 TOYOTA RAV4
1998-2001 TOYOTA SIENNA
2004-2008 TOYOTA SOLARA
1995-2012 TOYOTA TACOMA
2000-2006 TOYOTA TUNDRA
 

Position:
Front Right
 

Package Included:
1 x Window Switch

How To Replace Window Switch

1. Prepare tools: You need a Phillips screwdriver, a 10mm wrench and a plastic pry bar.

2. First, locate the control panel of the door lifter. Usually it is located on the front or rear of the armrest inside the door.

3. Use a screwdriver and wrench to remove the screws securing the control panel. This screw is usually 10mm.

4. After removing the screws, carefully pry open the control panel cover to separate it from the door lining.

5. Next, locate the screws on the lifter motor and remove. This screw is usually on the bottom of the motor.

6. After removing the screws, pull out the wire connector connected to the motor. These connectors usually come in the form of plugs that can be disconnected by simply pulling them back slightly.

7. At this point, the entire window lift switch has been removed. If parts need to be replaced, you can start installing the new parts. Just follow the disassembly sequence in reverse order.

8. Reconnect the wire connector and secure it to the motor. Make sure all connectors are connected correctly to their respective locations.

9. Put the lift motor back into place and tighten the screws at the bottom with a screwdriver and wrench.

10. Reinstall the control panel cover onto the door lining and secure it in place with a plastic spudger.

11. Finally, use a screwdriver and wrench to tighten the screws on the control panel.

    Now, the window lift switch has been successfully replaced or repaired. When performing these operations, make sure the vehicle is turned off and stationary to prevent accidents.