eBay

Brand：Supermicro

Model: AS-2023US-TR4

Product condition: Used

Front panel: no

HDD backplane: 12*3.5 inch SAS/SSD/SATA/NVME U.2 (only eight of the 12 disks support SAS and RAID, the remaining four disks only support U.2 or SATA/SSD and can not be grouped into arrays)

Hard drive bays: default, fully equipped

Cooling fan: default, fully equipped

Heat sink: default, 2 full

Processor: no

Memory: no

Motherboard: Default with

RAID Controller: default, 9364-8i array card controller

Riser card: default, support 3 double-wide GPU

Network: Integrated 4-port Gigabit network card I350-T4

Remote console: default with

PSU: default, 1000W power supply 2

Rack rails: no

Power cord: default, complimentary according to the number of power supplies

AS -2023US-TR4

A+ Server 2023US-TR4


Motherboard

H11DSU-iN


Processor/Chipset

CPU	Dual AMD EPYC™ 7001/7002* series Processors (* Board revision 2.x required) Socket SP3 Supports CPU cTDP up to 280W**
Cores	Up to 32 Cores (Board revision 1.x + 7001 Processors) Up to 64 Cores (Board revision 2.x + 7002 Processors)
Chipset	System on Chip (SoC)
Note	** Certain CPUs with high TDP higher than 225W may be supported only under specific conditions. Please contact Supermicro Technical Support for additional information about specialized system optimization


System Memory

Memory Capacity	32 DIMM slots Supports up to 4TB Registered ECC DDR4 2666MHz SDRAM (7001 Processors) Supports up to 8TB Registered ECC DDR4 3200MHz SDRAM (Board revision 2.x required + 7002 Processors) 8-channel memory bus
Memory Type	DDR4 2666 MHz Registered ECC, 288-pin gold-plated DIMMs (7001 Processors) DDR4 3200 MHz Registered ECC, 288-pin gold-plated DIMMs (Board revision 2.x required + 7002 Processors)
DIMM Sizes	4GB, 8GB, 16GB, 32GB, 64GB, 128GB, 256GB* (* Board revision 2.x required + 7002 Processors)
Memory Voltage	1.2V
Error Detection	Corrects single-bit errors Detects double-bit errors (using ECC memory)


On-Board Devices

SATA	SATA3 (6 Gbps)
IPMI	Support for Intelligent Platform Management Interface v.2.0 IPMI 2.0 with virtual media over LAN and KVM-over-LAN support ASPEED AST2500 BMC
Network Controllers	Provided via Ultra Riser Card
VGA	ASPEED AST2500 BMC


Expansion Slots

2U	1 PCI-E 3.0 x16 slot (FH, 10.5" L) 5 PCI-E 3.0 x8 slots (FH, 9.5" L) 1 PCI-E 3.0 x8 slot (LP) 1 PCI-E 3.0 x8 (internal proprietary LP slot) (Both CPUs need to be installed for full access to PCI-E slots and onboard controllers. See manual block diagram and AOC Support for details.)


Input / Output

SATA	12 SATA3 (6 Gbps) ports
LAN	Quad Gigabit LAN ports 1 RJ45 Dedicated IPMI LAN port
USB	3 USB 3.0 ports (2 rear + 1 Type A)
VGA	1 VGA port
SAS	12 SAS3 ports support via optional Add-on Card
NVMe	4 NVMe support with optional cables
Others	1 COM port (rear) 2 SATA DOM power connector TPM 1.2 header


System BIOS

BIOS Type	AMI 128Mb SPI Flash EEPROM
BIOS Features	Plug and Play (PnP) DMI 2.3 PCI 2.2 ACPI 5.1 USB Keyboard Support SMBIOS 3.1.1


Chassis

Form Factor	2U
Model	CSE-829U2TS-R1K62P-T


Dimensions and Weight

Height	3.5" (89mm)
Width	17.2" (437mm)
Depth	28.46" (723mm)
Package	9.96" (H) 24.60" (W) 45.43" (D)
Weight	Net Weight: 36 lbs (16.4 kg) Gross Weight: 72 lbs (32.7 kg)


Front Panel

Buttons	Power On/Off button System Reset button
LEDs	Power LED Hard drive activity LED 2x Network activity LEDs System Overheat LED / Fan fail LED / UID LED


Drive Bays

Hot-swap	12 hot-swap 3.5" Drive Bays: 12 SATA3 by default Optional Drive Support: 8 SAS3 + 4 SAS3/NVMe 2 rear hot-swap 2.5" drive bays


Backplane

HDD Backplane	Supports 12 SATA3 or 8 SATA3 + 4 NVMe or 12 SAS3 HDD


System Cooling

Fans	4 heavy-duty PWM fans with optimal fan speed control


Power Supply
1600W Redundant Power Supplies with PMBus
Total Output Power	1600W/1000W
Dimension (W x H x L)	73.5 x 40 x 203 mm
Input	100-127Vac / 13 - 9A / 50-60Hz 200-240Vac / 10 - 8A / 50-60Hz
+12V	Max: 83.3A / Min: 0A (100-127Vac) Max: 133A / Min: 0A (200-240Vac)
12Vsb	Max: 2.1A / Min: 0A
Output Type	25 Pairs Gold Finger Connector
Certification	Titanium Level [ Test Report ]


PC Health Monitoring

CPU	Monitors CPU Core Voltages, +12V, +3.3V, +5V, +5V standby, 3.3V standby, VBAT CPU switching voltage regulator
FAN	Up to 8-fan status tachometer monitoring Up to eight 4-pin fan headers Status monitor for speed control Pulse Width Modulated (PWM) fan connectors
Temperature	Monitoring for CPU and chassis environment CPU Thermal Trip Support Thermal control for 8x Fan connectors I²C Temperature Sensing Logic
LED	CPU / System Overheat LED
Other Features	Chassis Intrusion Detection Chassis Intrusion Header


Operating Environment / Compliance

RoHS	RoHS Compliant
Environmental Spec.	Operating Temperature: 10°C to 35°C (50°F to 95°F) Non-operating Temperature: -40°C to 70°C (-40°F to 158°F) Operating Relative Humidity: 8% to 90% (non-condensing) Non-operating Relative Humidity: 5% to 95% (non-condensing)