Sargent & Greenleaf (S&G) 6100 series electronic safe lock system with two compatible single 9v battery keypads and associated parts.

Lock Unit

• S&G 6100 series electronic safe lock body
• Standard 4-wire interface
• Tested with both keypads – communication verified - pad beeps/led lights when keys pressed.
• Lock responds correctly to keypad input
• Unlock/bolt actuation not tested (combination unknown, typical)

Keypads (2 included)

S&G 6120 Keypad (standard)

• Fully functional
• Tested with lock body
• LED and sounder respond correctly to keypress when attached to lock unit
• Communicates properly with lock

✔ S&G CWI-105 Keypad (lighted version of the older S&G 6120 keypad)

• Newer lighted keypad variant for 6100/6120 systems
• Front button activates keypad Red LED for keypad illumination
• Fully functional
• Tested with lock body

Repair performed:

• One connector pin (TS4) had separated from PCB (likely cold joint)
• Pin made and soldered to PCB, restoring full 4-pin connection

Now:

• Powers up normally
• LED illumination, keypress response, and sounder all function
• Communicates correctly with lock

🔧 Additional Parts Included

• Mounting bracket and actuator components
• Spring and linkage pieces
• Screws and small hardware
• Extra keypad housing components - housings are used

(These are included as a bonus)

 Testing Summary

• Both keypads connected to lock and powered via 9V battery
• Verified:
  • Keypad response (LED + audible beep)
  • Communication between keypad and lock
• Lock does not actuate without correct code (normal behavior - I don't know the code)

Suitable for replacement, repair, or parts use.  Based on condition, likely that one keypad lost a connector pin during use or installation and the keypad was replaced instead of having a pin made. That keypad has now been repaired and tested successfully.

It could be that the original keypad (non lighted) had some issue.   This is an estate sale lot.  The newer keypad looks unused, although the housing shows wear.   

What you see is what you get.   I have only examined a couple of gun safe S&G systems and am not an expert, but I can do general repairs.   Once the lighted keypad responded as the older keypad (and I noted pin 1 on the board - slightly different location than older 6120 keypad) I felt confident to sell these components.    I know nothing else about them.  

Item must be returned within 30 Days and Refund of purchase price shipping not included only will be given as: Money Back via pay pal or through the method paid. Buyer to pay return shipping as well. 3% restocking charge if item not broken. I don't end auctions early. Buy-it-now items are in my ebay store. If you have a concern about your purchase please contact me, as I work hard for your satisfaction starting with prompt shipping.

International Buyers Please Note:

Import duties, taxes, and charges are not included in the item price or shipping cost. These charges are the buyer's responsibility. Please check with your country's customs office to determine what these additional costs will be prior to bidding or buying.