Bond It Expanding PU Foam Gun Grade Cleaner Aerosol Cleaning Fluid Can - 500ml

 Description
A high strength, universal solvent cleaner that will remove PU foam from applicator guns

Bond It GUN FOAM CLEANER contains an
environmentally safe propellant, which complies
with the latest EU-regulations banning all CFC propellants.
Development and manufacture of our products is
subject to an approved quality assurance system
according to ISO 9001/EN 29001.

Uses
GUN FOAM CLEANER for applicator guns removes and
dissolves fresh, uncured PU-foam. The can is fitted
with an adapter ring which screws on to the gun. For
use without the gun, the can is fitted with a spray
head. This dual function meets the requirements of
the professional user.
The cleaner can's standard-thread adapter fits all
commonly used guns. Thorough cleaning of the
internal gun mechanism is enhanced by the
pressure the propellant exerts. The active
ingredients of GUN FOAM CLEANER are consistent with
the materials used in the manufacture of PU foam
applicator guns. Frequent use of GUN FOAM CLEANER
maintains them in good working order.
Important information for the general removal of
PU foams:
Because GUN FOAM CLEANER for applicator guns
contains acetone, it may dissolve or discolor
surfaces such as plastics, lacquers, coatings, paints,
textiles etc. Use with extreme care and test suitability before use.

Application
A suitable waste container and a cloth should be at
hand for disposal of waste fluids and wiping away
cleaner fluid and dissolved PU foam residues.
Remove the PU foam can from the gun. Use the
spray head on the GUN FOAM CLEANER can to clean
the adapter part and the outer body of the gun
Remove the red spray head from the GUN FOAM
CLEANER can and carefully screw the can on to the
gun. For safety reasons, the gun trigger should be
pulled whilst screwing on the cleaner can. This will
depresurise the gun.
Pull the trigger to purge the gun. As soon as
cleaning fluid appears at the tip of the gun, release
the trigger and allow the cleaner to work inside the
gun for approximately two minutes, then flush out
the gun into a waste container. Repeat this
procedure until only clear cleaner fluid comes from
the gun. Once the cleaning procedure is completed,
unscrew the GUN FOAM CLEANER can from the gun.

Important: Only fresh foam can be removed with
GUN FOAM CLEANER. Cured foam can only be
removed mechanically or with Bond It CURED FOAM
REMOVER. Note: Sharp instruments must never be
used on PU foam applicator guns as this may
damage the protective coating of the gun

Storage Conditions
Presurissed container; protect from sunlight and do
not expose to temperatures exceeding 50°C.
Store cans upright.

Disposal of Containers
Do not leave empty containers where residue could
be harmful to children, animals or the environment.
Replace lids and remove any containers to a central
disposal point in accordance with local regulations.
Any spillages should be mopped up immediately
with an inert, absorbent material such as sand.
Do not pierce or burn, even after use. Do not spray
on a naked flame or any incandescent material.
Completely emptied GUN FOAM CLEANER cans are
suitable for recycling subject to individual national
rules and regulations

Safe Handling Precautions
DANGER! Extremely flammable aerosol. Please refer
to separate material safety data sheet for full
handling, use and storage instructions. Keep out of
reach of children. It is the users responsibility to
determine suitability for use. If in doubt contact our
Technical Department for advice

Note: this information is for general guidance only, since site
conditions and Labour are beyond our control. It is
recommended that users make their own tests to determine
Suitability.

Container Sizes:
Code: BDCF1
Size: 500ml
Barcode: 5060021361073

Package Content
1x Cleaning Fluid For Gun Foam Applicator Cleaner for Polyurethane Foam