Package Include:
1 x 4 Row Aluminum Radiator
1 x Radiator Cap
1 x Aluminum Shroud
1 x 12" Fan (Includes mounting kits)
Radiator Size:
High Performance Racing Spec.
4-Row of tubes Core Racing Design
Condition: New
Core Size: 13 7/9'' x 14 1/9'' x 2.5"
Overall Size: 14 3/8'' x 18 2/7''
Inlet: 1 1/4''
Outlet: 1 1/4''
Transmission Oilcooler: No
Fitment:
For 1992-2000 Honda Civic 1.5L 1.6L l4
For 1993-1997 Honda Civic Del Sol 1.5L 1.6L l4
For 1994-2001 Acura Integra 1.8L l4
Fits Models with Manual Transmission and D15 D16 B16 B18 Engines Only
12'' Fan Specification:
Volt :12v
Maximum Fan CFM: 1730 cfm
Fan Diameter: 12.050''
Number of Blades: 10 S-Type blade
Blade Material: Plastic
Includes the Mounting Tabs for an Easy Zip Tie Installation
How to clean radiator:
1. Start the vehicle, to rise to normal temperature. Slowly open the tank cover, the fluid shake from the tank after filling the mouth, the cleaner can be mixed with any brand of coolant. Idle running not less than 15 minutes, not cleaning vehicles not less than 30 minutes for two years. And then discharge coolant, flush water tank, until out of clear water, suitable for any water cycle system.
2. After cleaning, after waiting for pipeline rehabilitation add fluid to water tank, and inject new coolant and water purification.
How to replace the radiator:
1. Disconnect the battery.
2. Drain the radiator fluid into a suitable container.
3. Remove the old radiator:
-Take off any plastic covers around the radiator.
-Disconnect the electrical connector to the fan, and unbolt and remove the fan assembly.
-Disconnect the radiator hoses from the radiator.
-Disconnect the transmission cooling lines from the bottom of the radiator.
-Remove any clamps, brackets, or screws holding the radiator inside its frame.
-Lift the radiator up and out of the car.
4. Install the new radiator:
-Slide the new radiator into place.
-Connect any clamps or brackets that hold the radiator in place.
-Connect the transmission cooling lines carefully.
-Connect the engine cooling hoses to the radiator.
-Replace the fan and fan shroud.
-Reconnect the fan electrical connection.
-Replace the plastic covers.
5. Fill the radiator with fluid.
6. Check your work to make sure that there are no leaks.
(Tools need to be prepared: Screwdrivers, Wrenches, Drain pan)
Note: Do please keep children and pets away when replacing the radiator)
Note:
1. Project operation, the vehicle normal temperature 60 to 80 degrees.
2. Add detergent if the tank is too full can take some antifreeze.