Easy to install and use: 7PIN (ON)-OFF-(ON) rocker switch with DPDT design (double pole double Throw), rated at 20AMP/12VDC and 10AMP/24VDC. Can be installed or replaced on the Nilight rocker switch panels. It is easy and simple to set up. Can control 2 loads.
Dual Operation: This momentary electrical system switch is used for jogging or inching operations. A DPDT switch is equivalent to two SPDT switches. It routes two separate circuits. Connecting each of two inputs to one of two outputs. The position of the switch determines the number of ways in which two contact can be routed. Always make sure you are using a switch and wire sufficient to handle the load you are carrying. In higher draw applications, a relay may be needed.
Wide Application: Can be used to replace Rotary, Drum, Cable and used to control Winch,Pump,Reclining Media Room Seats,Auto Bilge Pump. Fit for all cars, SUVs, ATVs, UTVs, Yachts, Trailers,Campers, Caravans etc; Also a great replacement for RV or Electric Trailer Power, Travel Trailers and slideout Power awning switches. Momentary Automatic Reset action, Resetting returns to off when released. Simply connect power and ground and two DC motor leads and the switch will reverse the motor direction.
Sturdy and durable: made of high-quality plastic and well-conductive pins; ensure long lasting durability,highly optimized for general use and will give you a pleasant experience.
Package Includes: A 7 PIN switch, jumper wires set and a wiring diagram. 2 Year Warranty by Nilight.

Product description

Nilight Momentary Switch

7PIN (ON)-OFF-(ON ) rocker switch with 16 AWG jumper wires.

Material: Superior ABS+PC;Rated at 12V 20A and 24V 10A DC.

Mounting Hole Size: 1.43"(37mm) x 0.84"(21.3mm).DPDT design,can control 2 loads.

Fits most cars, SUVs, ATVs, UTVs, 4X4, motorcycles, trucks, Jeep Wranglers, boats, yachts, and other off-road vehicles.

Mainly used together with wiring harness to control the up/down, clockwise/counterclockwise motion of DC loads (e.g. motors, hoists, cranes, linear actuators etc.). Such as Winch, Pump, Horn, Reclining Media Room Seats, Auto Bilge Pump etc.

LED Lighting Effect

Upper LED Illuminated

The upper light is on when the switch is pressed, and it stops working when let it off.

Lower LED Illuminated

The lower light is on when you press the switch down, and it will return off position when you remove your finger.

Product Features

Non-Locking Design

The switch is very flexible for turning on or off. Automatic rebound when finger released. It can stand up to 10,000 times pressing under normal use.

Easy Installation

This switch is simple to install, product comes with a wiring diagram which make it easy to wire the jumper wires in two seconds.

Premium Jumper Wires

High quality 16 gauge jumper wires, the Tin-plated copper terminals on the wire is of good stability, wear resistance, corrosion resistance.

Excellent Product

Made of ABS and PC of premium quality, the switch is impact and heat resistant. DPDT design, this on off on switch can control 2 loads.

Easy Installation

Installation on switch holder

The 5 pin rocker switch can be installed on Nilight rocker switch holder housing for better using effect.

Installation on switch panel

It can also be replaced to any defective 5 PIN switches. Convenient and cost-effective.

Wide Applications

Replacable Rocker Switch

The switches can be replaced with any defective 5 PIN SPST switches, convenient and cost-effective.

Wide Application

Suitable for most DC 12V-24V cars, UTV/ATV, trucks, trailer, RV, caravan, bus, marine boat, yacht, airplane, etc.

Use on Marine Boat

Marine-grade Construction and IP65 Waterproof.

best for marine but submerged in water operation is not recommended.

Use on UTVs

It's dimension is the same as the original factory switch on UTV vehicle, which can replace damaged UTV switches without the need for drilling holes.