TOP Reasons to Choose ANCEL DP500:

1.Mileage Correction--Write/Read ODO,Read/Write EEPROM,Read/Write Flash （depend on model, year and dashboard type）

2.Key Programming--Add/Erase Key,All Key Lost Programming,Programming Remote,Key Numbers Reading,Reading Pin Code ,Reading EEPROM Chip,Remote Matching

3.Support 11 Special Functions:Oil Reset Service,ABS Bleeding,Gear Learning,CVT Reset,Battery Match,EPB Adaptation,TPS Adaptation,Steering Angle Reset,DPF Regeneration,Injector Coding,Suspension Matching

4.7 inch Android Tablet:Comes with a browser, you can surf the Internet, search for information, listen to songs, take pictures, etc...

5.Multi-language:English,Spanish,Polish,Portuguese,French, German,Italian,Russian (need serial to add languges)

6.1 Year Free Update: One-click Free Update Via Wifi. After one year, the update fee is 299 USD, no update no charged, the original function is free for life, if you update it,can get more models in future

7.Remote Assistance: Assist you with issues via remote client

Key Programming Functions:

1.Add/Erase Key 

2.All Key Lost

3.Programming Remote 

4.Key Numbers Reading 

5.Reading Pin Code 

6.Reading EEPROM Chip 

7.Remote Matching

 8.Reset ECM

Odometer Correction /Mileage Adjust

1.Write/Read ODO 

2.Read/Write EEPROM 

3.Read/Write Flash

Support 11 Special Functions:

✅Oil Reset Service:The lightening of the car maintenance light indicates that the vehicle needs maintenance.Reset the mileage or driving time to zero after the maintenance,so the maintenance light will go out and the system will start a new maintenance cycle.

✅ABS Bleeding:When the ABS contain air,the ABS bleeding function must be performed to bleed the brake system to restore ABS brake sensitivity.If the ABS computer,ABS pump,brake master cylinder,brake cylinder,brake line,or brake fluid is replaced,the ABS bleeding function must be performed.

✅Battery Match: This function enables you to perform a resetting operation on the monitoring unit of vehicle battery,in which the original low battery fault information will be cleared and battery matching will be done.

✅Steering Angle Reset: To reset the steering angle,first find the relative zero point position for the car to drive in straight line.Taking this position as reference,the ECU can calculate the accurate angle for left and right steering.After replacing the steering angle position sensor ,replacing steering mechanical parts(such as steering gearbox,steering column,end tie rod,steering knuckle),performing four-wheel alignment,or recovering car body,you must reset the steering angle. 

✅DPF Regeneration: is used to clear PM(Particulate Matter)from the DPF filter through continuous combustion oxidation mode(such us high temperature heating conbustion,fuel additive or catalyst reduce PM ignition conbustion)to stabilize the filter perfornance. 

✅Injector Coding: Writing injector actual code or rewrite code in the ECU to the injector code of the corresponding cylinder so as to more accurately control or correct cylinder injection quantity.After the ECU or injector is replaced,injector code of each cylinder must be confirmed or re-coded so that cylinder can better indentify injectors to accurately control fuel injection. 

✅Suspension Matching: This function can adjust the height of the body.When replacing the body height sensor in the air suspension system,or coontrol module or when the vehicle level is incorrect,you need to perform this function to adjust the body height sensor for level calibration.

And More: Gear Learning /CVT Reset /EPB Adaption /TPS Adaption 

Supported Multi-languages

English,Spanish,Polish,Portuguese,French, German,Italian,Russian

PLEASE NOTE: The default language of the device is English, if you need to use other languages, please contact us and provide your product serial number, we will contact the engineer to open the language for you, thank you