RFX Race Series Kill Buttons are designed as exact OEM replacement parts, ensuring a seamless fit and reliable performance.

Each kill button is supplied with the same couplings, fasteners, connectors, and precise cable lengths as the original component, guaranteeing hassle-free installation and compatibility.

Available for a wide range of bike models.

Product Features:

• OEM replacement
• Accepts all original connectors
• OEM cable length

Fitting Instructions:

• Start by removing the front number plate.
• Carefully snip any cable ties holding the start and stop switch cables to the bars then un-screw the clamps and let these hang down.
• Locate the connector for the switch on the bike, these are often close by to the headstock on the chassis but sometimes can be under the tank.
• Unclip the connector and remove the switch taking a note of the routing for the wiring.
• Clean the connector using contact cleaner such as Maxima Electrical Contact cleaner.
• Loosely attach the new switch on to the handlebars in the desired position.
• Route the wires as per the old switch and clip the connector together.
• Check all free pay in the wires by turning the bars to full extension and making sure the wires don�t pull tight, adjust if necessary.
• Re-fit cable ties to the wires if possible positioning the cables to the back of the bars to prevent damage from roost.
• Re-fit your number plate.

Majority of our listings are for a direct replacement for your original part.
Our parts are made of quality and are designed to meet or exceed the original OEM Standards.
Our products are often a cost effective alternative to genuine OEM Parts.

Please note � the models of bike we state in our listings are for general guidance only. Please make sure this item will fit your bike before purchasing.
Also, we cannot guarantee fitment to any non-UK models.