Fitment:

For Toyota Tacoma 2005-2020

Package Included:

1pcs of Wheel Hub Bearings

How do I know if I have a bad wheel hub assembly:

A failing wheel hub assembly can present a variety of symptoms including:

1. The steering wheel may shake while driving.

2. Growling, humming, squeaking, chirping or squealing from the tires when driving at 30-45mph.

3. ABS light will come on if the sensor isn’t reading properly or if the signal is lost.

How to install the Wheel Hub Bearings？

1.Do not reuse the wheel stud.

2.Do not reuse the cotter pin.

3.Place a washer as shown to install the wheel studs by using the tightening force of the nut.

4.Clean the mating surfaces of the joint sub-assembly and the wheel hub and bearing. Apply lubricant to the surface of the joint sub-assembly.

5.Hold the wheel hub and bearing using a suitable tool. Tighten the wheel hub lock nut

6.Since the drive shaft is assembled by press-fitting, use a torque wrench to tighten the wheel hub lock nut. Do not use a power tool.

7.Too much torque causes axle noise. Too little torque causes wheel bearing looseness. Tighten the wheel hub lock nut to the specification.

8.When installing a the cotter pin and the nut retainer, securely bend the cotter pin to prevent rattles.

9.Align the matching marks on the disc brake rotor and on the wheel hub and bearing.