Fitment:
2006-11 Buick Lucerne Rear Driver or Passenger Side General Motors OEM 22895545
2007-13 Chevy Avalanche 1500 Rear Driver or Passenger Side General Motors OEM 22895545
2008-10 Chevy HHR Front Passenger Side General Motors OEM 22895545
2008-13 Chevy Silverado 1500 Rear Driver or Passenger Side General Motors OEM 22895545
2007 Chevy Silverado 1500 Rear Driver or Passenger Side New Body Style General Motors OEM
22895545
2007 Chevy Silverado 2500 HD Rear Driver or Passenger Side New Body Style LT General Motors
OEM 22895545
2008-14 Chevy Silverado 2500 HD Rear Driver or Passenger Side LT General Motors OEM
22895545
2008-14 Chevy Silverado 3500 Rear Driver or Passenger Side LT General Motors OEM 22895545
2007 Chevy Silverado 3500 Rear Driver or Passenger Side New Body Style LT General Motors
OEM 22895545
2009-17 Chevy Traverse Front Passenger Side General Motors OEM 22895545
2008-13 GMC Sierra 1500 Rear Driver or Passenger Side General Motors OEM 22895545
2007 GMC Sierra 1500 Rear Driver or Passenger Side New Body Style General Motors OEM
22895545
2008-14 GMC Sierra 2500 HD SLE Power Window Switch Rear Driver or Passenger Side General
Motors OEM 22895545
2007 GMC Sierra 2500 HD New Body Style SLE Power Window Switch Rear Driver or Passenger
Side General Motors OEM 22895545
2008-14 GMC Sierra 3500 Rear Driver or Passenger Side SLE General Motors OEM 22895545
2007 GMC Sierra 3500 Rear Driver or Passenger Side New Body Style SLE General Motors OEM
22895545
 

Position:
Front Right
 

Package Included:
1 x Window Switch

How To Replace Window Switch

1. Prepare tools: You need a Phillips screwdriver, a 10mm wrench and a plastic pry bar.

2. First, locate the control panel of the door lifter. Usually it is located on the front or rear of the armrest inside the door.

3. Use a screwdriver and wrench to remove the screws securing the control panel. This screw is usually 10mm.

4. After removing the screws, carefully pry open the control panel cover to separate it from the door lining.

5. Next, locate the screws on the lifter motor and remove. This screw is usually on the bottom of the motor.

6. After removing the screws, pull out the wire connector connected to the motor. These connectors usually come in the form of plugs that can be disconnected by simply pulling them back slightly.

7. At this point, the entire window lift switch has been removed. If parts need to be replaced, you can start installing the new parts. Just follow the disassembly sequence in reverse order.

8. Reconnect the wire connector and secure it to the motor. Make sure all connectors are connected correctly to their respective locations.

9. Put the lift motor back into place and tighten the screws at the bottom with a screwdriver and wrench.

10. Reinstall the control panel cover onto the door lining and secure it in place with a plastic spudger.

11. Finally, use a screwdriver and wrench to tighten the screws on the control panel.

    Now, the window lift switch has been successfully replaced or repaired. When performing these operations, make sure the vehicle is turned off and stationary to prevent accidents.