Item Description:

•Built to strict quality control standards
•Ready to use, Direct Replacement
•Superior quality parts
•100% Factory tested
 

Product Features:

    1,Fits either LH (Driver Side) or RH (Passenger Side)  REAR

    2,Manufactured to meet or exceed expectations for performance and fit

    3,5 lugs

    4,High quality seal design ensures a clean, long lasting hub bearing

Compatible Vehicles:

• Fits Lexus NX200t 2015-2017 AWD Only
• Fits Lexus NX300 2018-2021 AWD Only
• Fits Lexus NX300h 2015-2021 AWD Only
• Fits Toyota RAV4 2006-2018 4WD/ AWD Only

The wheel hub bearing needs to be replaced in the following situations（notes）

• A humming, rumbling or growling noise that increases with acceleration or as the vehicle turns
• Vibration, felt in the steering wheel, which changes with vehicle speed or as the vehicle turns
• Looseness or excessive play* in the steering wheel (especially while driving over rough road surfaces)
• A loud, constant grinding noise when driving the vehicle (heard in the most severe cases of a wheel bearing failure)
• Puling to one side when braking
• Roughness or vibration when rotating the wheel with the vehicle off the ground
• Excessive brake pedal “play” (can also indicate excessively loose wheel bearings)
• ABS light illumination or system issues (may be related to failure of the ABS sensor in the hub assembly or the internal sensor in the wheel bearing)

Purpose and Commitment :

•  We insist on innovation and development.
•  Our everlasting purpose is high quality , Integrity-based and Full service.

Removing and Installing a Hub Unit Bearing:

A.Hub Unit Bearing Removal

1.Raise vehicle and remove lug nuts and wheel.
 

2.Remove the brake caliper and rotor. Support the brake caliper with an “S” hook or a piece of wire. 

3.Remove the axle nut, using an axle nut socket. Follow the manufacturer’s instructions for nut replacement.

4.Before removing hub unit, make a note of the proper orientation and positioning of the sensor wire and bearing. Disconnect the ABS sensor wire from its mating connector point and positioning clips. 

5.Remove the steering knuckle attachment bolts. You may need a puller to remove the hub assembly. Do not damage the knuckle or axle shaft.
 

6.Clean and inspect the steering knuckle. Remove any debris, nicks or burrs using a fine file, wire brush, emery cloth or honing stone.

B.Hub Unit Bearing Installation

1.Insert the new hub assembly into the steering knuckle. Check the positioning of the splines on the axle shaft while inserting the hub assembly. Never force the hub assembly on the shaft or strike with a hammer. 

2.Torque the knuckle-bearing mounting bolts to the vehicle manufacturer’s specification using a torque wrench. Do not use an impact wrench.
 

3.Connect the new ABS sensor that comes already attached to the new bearing to its mating connection point and clips in the wheel well and frame area.
 

4.Install the axle nut. Tighten the nut to the vehicle manufacturer’s torque specification using a torque wrench. Do not use an impact wrench.

5.Replace the brake rotor and brake caliper. All components should be cleaned from debris and burrs. 

6.Replace the wheel and torque the lug nuts. Follow the vehicle manufacturer’s recommendations regarding torque specification and re-torque requirements.

Warning failure to observe the following warnings could create a risk of death or serious injury!!!