Fitment:

For Ford Ranger 2000 4Wd/4X4 - After 06/22/2000 Manufacture Date
For Ford Ranger 2001-2009 4Wd/4X4 Only - Round Abs Wire Connector
For Mazda B4000 2001-2009 4Wd/4X4
For Mazda B3000 2001-2002 4Wd/4X4
For Ford Explorer 1995-2001 Awd; 4Wd Models Only
For Mercury Mountaineer 1997-2001 Awd; 4Wd Models Only
For Ford Explorer Sport 2001-2003 4Wd, 4-Wheel Abs
For Ford Explorer Sport Trac 2001-2005 4Wd, 4-Wheel Abs
For Mazda B2300 2003-2009 All Mode

Package Included:

2pcs of Wheel Hub Bearings

How do I know if I have a bad wheel hub assembly:

A failing wheel hub assembly can present a variety of symptoms including:

1. The steering wheel may shake while driving.

2. Growling, humming, squeaking, chirping or squealing from the tires when driving at 30-45mph.

3. ABS light will come on if the sensor isn’t reading properly or if the signal is lost.

How to install the Wheel Hub Bearings？

1.Do not reuse the wheel stud.

2.Do not reuse the cotter pin.

3.Place a washer as shown to install the wheel studs by using the tightening force of the nut.

4.Clean the mating surfaces of the joint sub-assembly and the wheel hub and bearing. Apply lubricant to the surface of the joint sub-assembly.

5.Hold the wheel hub and bearing using a suitable tool. Tighten the wheel hub lock nut

6.Since the drive shaft is assembled by press-fitting, use a torque wrench to tighten the wheel hub lock nut. Do not use a power tool.

7.Too much torque causes axle noise. Too little torque causes wheel bearing looseness. Tighten the wheel hub lock nut to the specification.

8.When installing a the cotter pin and the nut retainer, securely bend the cotter pin to prevent rattles.

9.Align the matching marks on the disc brake rotor and on the wheel hub and bearing.